Jura Capresso F505 Coffeemaker User Manual


 
12
For Example: 210 ML
POWDER
Your product is being prepared.
READY
11. Drawing off hot water
If you do not change the settings using the Rotary Switch
(1), the water quantity last adjusted will be drawn off auto-
matically.
Install the hot water nozzle (see Fig. 5 ) to obtain perfect
water flow. Do not replace the replaceable hot water nozzle
(16) directly after drawing off water, because the nozzle is
hot after the draw-off operation.
At the start of the water draw-off operation there can be
splashing Avoid direct contact with the skin!
READY
Place a cup under the replaceable hot water nozzle (16).
Open the steam / hot water draw-off tap (14) (Fig. 13).
The illuminated ring (2) is active.
For example, 140 ML
WATER
Adjust the required water quantity by turning the Rotary Switch
(1).
For example, 200 ML
WATER
If the required water quantity is reached, the following message
is displayed:
CLOSE TAP
Close the steam / hot water draw-off tap (14).
READY
Before CLOSE TAP water may still escape the system.
12. Drawing off steam
The steam function is used for the preparation of milk foam
as well as for the Easy-Auto-Cappuccino Frother (15) clean-
ing programme.
With the optionally available 2-stage frothing nozzle, liquids
can be heated and frothed using the steam function.
Make sure that the nozzle is correctly fitted when drawing
steam. If the nozzle becomes blocked with particles of milk
residue or is incorrectly assembled, a danger can arise during
use whereby the nozzle may jump off.
Due to the system design, some water will escape at first
when steam is drawn. However, this will not affect the result
in any way.
When drawing steam, spluttering can occur at the start. The
nozzle becomes hot in use. Avoid any direct skin contact.
READY
Press the steam pre-selection key (8).
HEATING
STEAM
READY
To draw off steam, open the steam/hot water draw-off tap (14)
(Fig. 13).
The illuminated ring (2) is active.