Filter
Top Products
21
Cause Action
CLEAN UNIT You have drawn off coffee 220 times or run Clean as described in chapter 14.6
the rinsing program 180 times
Message still displayed, although machine Run cleaning program again; this time do not
cleaned add cleaning tablet
UNIT CALCED The espresso/coffee machine sector needs Run decalcifying program as described in
decalcifying chapter 16
Message still displayed, although machine Run cleaning program again; this time using water
decalcified only and without decalcifying agent
FAULT 2 Temperature too low – Switch device off
– Leave device for approx. 2 hours at room
temperature
– Switch device on
FAULT 8 Initialisation problem Switch device off, disconnect from mains,
switch on
20. Problems
Problem Cause Action
Coffee only flows in dribs – Powder too fine – Adjust grinder to a coarser grinding
and drabs while drawing off
– Run the rinsing programme once or twice.
– If the problem persists, run cleaning programme
Coffee flow is stopped – Not enough coffee powder in the system – Draw off one cup of coffee
after pre-brewing
Grinder is extremely noisy – Foreign element in grinder – Proceed as described in chapter 14.5
E