Filter
Top Products
15
E
Ⅲ Empty the drip tray and the grounds container and put both of
them back in. The symbol lights up.
After each cleaning operation the filler funnel for the 2nd
coffee type should be cleaned.
13. Descalcifying
The machine has an integrated de-scaling programme. If you use a
Claris filter cartridge, your machine does not need de-scaling. Only
use Jura cleaning tablets. They are available from your Jura dealer.
If the machine needs de-scaling, the symbol flashes.
You can continue to draw off coffee and hot water/steam and
then run the de-scaling programme later.
Only run the de-scaling programme when the machine has
been switched off for at least 2 hours and has cooled down
well. The de-scaling programme is started with the machine
switched off. Once it has started, the de-scaling programme
must not be interrupted.
Ⅲ Switch your machine off with the ON/OFF switch and leave
it to cool down for 2 hours.
Ⅲ Remove the water tank and empty it.
Ⅲ Press the maintenance key (4) for about 3 seconds. The ,
symbols light up.
Ⅲ Empty the drip tray and the grounds container and put both of
them back in again. The symbol goes off and the ,
symbols light up.
Ⅲ Completely dissolve the contents of one blister (2 tablets) in 0.5
litres of water in a vessel and pour the mixture into the water
tank. Put the tank back in again. The symbol appear.
Ⅲ Turn the selector switch for hot water/steam (12) to the position
. The symbol go off and the , symbols light up.
Ⅲ Place a sufficiently large vessel under the pivoting nozzle for hot
water/steam (13) and press the maintenance key (4).
The lighting of the symbol and the flashing of the symbol
show you that the de-scaling process has been activated.
Ⅲ If the symbol lights up, empty the drip tray (if necessary) and
put it back in again. The symbol lights up.
Ⅲ Turn the selector switch for hot water/steam (12) back to the
position .
The de-scaling process is continued de-scaling solution is guided
into the drip tray in the interior of the machine.
Ⅲ The , , symbols light up.
Rinse the water tank out well and fill it with cold fresh
tap water. Then put it back into the machine again. Place a
sufficiently large vessel under the pivoting nozzle.
Ⅲ Empty the drip tray and put it back in again. The , symbols
light up.
Ⅲ Turn the selector switch for hot water/steam (12) to position .
Ⅲ Place a sufficiently large vessel under the pivoting nozzle for hot
water/steam (13) and press the maintenance key (4).
The lighting of the symbol and flashing of the symbol show
you that the de-scaling process has been activated.
Ⅲ If the , , symbols light up, empty the drip tray (if neces-
sary) and put it back in again.