Filter
Top Products
the machine does not prompt you,
• READY. Push and hold the Rinse button until display shows
RINSE. The Dial illuminates.
• Turn the Dial until display shows CLEANING. Push the Dial.
Display shows EMPTY DRAWER.
• Continue with step 3 above.
20c. DECALCIFYING PROCEDURE
The machine has an integrated decalcifying program. When the
display shows DESCALE MACHINE / MACHINE READY it is
time to decalcify the machine. You can still make coffee.
However, it is highly recommended that you decalcify the machine
within the next 3 to 4 days.
Please note: If you use the Clearyl water cartridge and the
display shows DESCALE MACHINE / MACHINE READY, then
your cartridge function is not activated. Follow the instructions in
chapter 16a to program the Clearyl Cartridge function.
Important: The decalcifying program must not be interrupted.
DECALCIFYING AGENT: Only use our special decalcifying
tablets. For supplies see chapter 22.
CAUTION: Never use vinegar or any other decalcifying agent.
This might damage internal parts of the machine.
1. Push the Rinse button. The display shows
EMPTY DRAWER.
2. Remove and empty the drawer and used coffee container
and replace complete assembly (Fig. 21).
Important: Even if the drawer and the used coffee container
are empty, you still need to remove the tray for approx. 20
seconds and then replace it. The display shows
SOLVENT IN
TANK
.
3. Make sure the water tank is empty. Completely dissolve three
of the large square tablets in 16 oz. of water and pour this
mixture into the water tank.
4. Replace water tank. Place a large container (at least 20 oz.)
underneath the frother.
5. The displays shows
SOLVENT IN TANK OPEN TAP. Turn the
Steam/Water Selector to the water symbol. The machine will
pump the mixture through the frother in intervals. During this
procedure the display shows
DECAL ON. When this cycle is
finished the display shows SHUT TAP.
6. Turn the Steam/Water Selector back to the cup symbol.
The display shows
DECAL ON. Now the machine pumps the
mixture through the coffee spout into the drawer.
7. When this cycle is completed the display shows
EMPTY
DRAWER. Remove the container from underneath the
frother. Carefully lift and remove the drawer, empty and
thoroughly rinse all parts and replace. The display shows
FILL WATER.
8. Remove the water tank, rinse thoroughly, fill with cold fresh
water and replace.
9. Place a large container (at least 20 oz.) underneath the
frother. The display shows
OPEN TAP.
10. Turn the Steam/Water Selector to the water symbol.
The machine will pump hot water through the frother in
intervals. During this procedure the display shows
DECAL ON.
When this cycle is finished the display shows SHUT TAP.
11. Turn the Steam/Water Selector back to the cup symbol.
The display shows
DECAL ON. Now the machine pumps hot
water through the coffee spout into the drawer.
12. When the cleaning cycle is completed the display shows
21.