Filter
Top Products
17
14.4 Fill beans
Ⅲ FILL BEANS
Ⅲ Fill beans as described in chapter 3.3.
The message FILL BEANS will only disappear after drawing
off a coffee. We recommend cleaning the bean container
from time to time with a dry cloth before you refill beans.
Switch off the machine for this purpose.
14.5 Removing foreign objects
Ⅲ Switch off your machine by pressing ON/OFF key
.
Ⅲ Remove plug from power socket.
Ⅲ Open bean container (13) and remove the beans. The remaining
beans can be removed with a vacuum cleaner.
Ⅲ Loosen both screws in the bean container and then remove
container (Fig.5 + 6)
Ⅲ Remove any remaining beans with a vacuum cleaner.
Ⅲ Put the spanner on (Fig.7).
Ⅲ Now turn spanner anticlockwise until the foreign object loosens.
Ⅲ Remove remaining powder with a vacuum cleaner.
Ⅲ Replace bean container and fasten screws.
14.6 Clean machine
Ⅲ CLEAN UNIT
After coffee, etc., has been drawn off 220 times or after 180 rinsing
programs have been run, the machine must be cleaned. You can
continue to draw off coffee and hot water / steam. However we
recommend that you clean the machine (as described in chapter 15)
within the next few days.
Ⅲ CLEAN NOW
An acoustic signal indicates the need of an immediate cleaning.
14.7 Unit calcified
Ⅲ UNIT CALCED
The machine signals when decalcifying becomes necessary.
Under the correct implementation of Claris filter cartridges,
decalcifying of the machine becomes unnecessary. For
further indications read Chapter 7 “Use of Claris filter cart-
ridges“.
14.8 Cleaning metal contacts
Ⅲ EMPTY TRAY / CLEAN CONTACTS
Ⅲ The remnants of the calcified deposits in the area of the metal
contacts must be removed. Proceed as follows:
Ⅲ Rinse fastenings in groove (B) as well as the metal contacts (A)
with hot water and some washing-up liquid. Then clean the
fastenings in groove (B) as well with a brush (Fig. 8).
14.9 General cleaning instructions
Ⅲ Never use abrasive articles or corrosive chemicals to clean your
machine.
Ⅲ Wipe down the casing inside and out using a soft, damp cloth.
Ⅲ Clean the pivoting nozzle after every use.
Ⅲ After warming milk, draw off some hot water to clean the
pivoting nozzle inside.
Ⅲ You can take off the Auto-cappuccino for a thorough cleaning.
Ⅲ The water tank should be rinsed and filled with clean water
daily.
If you notice any furring in the water tank, this can be de-
calcified separately with a customary decalcifying agent.
Remove the tank from the machine for this purpose.
If a Claris filter cartridge is used, remove it beforehand.
E