Filter
Top Products
22
14.3 Emptying the drip tray
Ⅲ EMPTY
TRAY
If this information is displayed, the machine will no longer
dispense coffee or steam, and the tray must be emptied.
Ⅲ Carefully take out the drip tray (1) – which contains water – and
the integrated coffee grounds bin.
Ⅲ TRAY
MISSING
Ⅲ Place the empty, clean drip tray (1) and integrated coffee
grounds bin back into the IMPRESSA.
Ⅲ SELECT PRODUCT
14.4 Drip tray missing
Ⅲ TRAY
MISSING
If this information is displayed, the machine will no longer
make coffee. The drip tray (1) and integrated coffee grounds
bin have not been installed or not been installed properly.
Ⅲ Insert the drip tray (1) and integrated coffee grounds bin.
Ⅲ SELECT PRODUCT
14.5 Filling the bean tank
Ⅲ FILL
BEANS
If this information is displayed, the machine will no longer
make coffee. However, the machine will still dispense hot
water and steam. Refill beans as described in Chapter 2.4.
Ⅲ SELECT PRODUCT
14.6 Removing stones from the grinding gear
Ⅲ Switch the machine off using the ON / OFF key (11).
Ⅲ Turn the power switch (27) off.
Ⅲ Open the lid of the bean tank (16) and remove the aroma preser-
vation cover (15).
Ⅲ Remove any beans with a vacuum cleaner.
Ⅲ Remove the screw in the bean tank (Fig. 9) and fold the finger
protection device up (Fig. 10).
Ⅲ Insert the key (Fig. 11).
Ⅲ Now turn the key counter-clockwise until the jammed stone is
released.
Ⅲ Remove any remaining powder with a vacuum cleaner.
Ⅲ Fold the finger protection device (Fig. 10) down and screw it
tight.
Ⅲ Fill the bean tank with fresh beans.
14.7 Changing the filter
After 50 litres of water the filter cartridge will need to be
replaced. The display will prompt you to change the filter.
Refer to Chapter 5.2 “Changing the filter”.
14.8 Prompt to run cleaning cycle
After having dispensed 220 products or after 80 rinsing cycles, the
IMPRESSA must be cleaned. You will be informed of this by a
message on the display. The machine will still make coffee, hot
water and steam. However, we recommend that you should run the
cleaning cycle (see Chapter 15) within the next few days.
Ⅲ SELECT PRODUCT /
CLEAN MACHINE