Filter
Top Products
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
34
Fit the replacement control and re-assemble in the
reverse order.
5.5 To Remove the Right-hand Oven Element
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the oven inner back (see 5.2).
Remove the two screws from the top of the element
and the one from the bottom of the element
(Fig.9-6). Carefully lift the element out, disconnecting
the terminals connected to the element (noting their
positions). If it is not possible to disconnect the leads in
this way, pull the cooker forward to gain access to the
rear, remove the screws securing the electric cover to
the back sheet, remove the cover and disconnect the
terminals from the rear.
Fit the new element and reassemble in the reverse
order. Check the operation of the oven.
5.6 To Remove the Left-hand Oven Bottom and Top
Elements
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Bottom Element
Pull the cooker forward to access the cover boxes at
the rear of the unit. Remove the xings that secure the
cover and lift it clear.
Remove the two screws ‘A’ and allow the plate to drop
down (Fig.9-7). Remove the two screws ‘B’, lower the
upper plate and remove through the slot in the cooker
back (Fig.9-8).
Undo the terminal connections, noting their positions.
Remove the element xings and withdraw the element.
Replace the element and re-assemble parts in reverse
order.
Top Element
Open the left-hand oven door and undo the xings that
secure the heat shield. Remove the top element bracket
xings and withdraw element. Replace the element and
re-assemble parts in the reverse order.
Check the oven operation.
6 Doors
6.1 To Remove the Grill Door
Remove the left-hand side panel – see 3. Remove
the plinth (4 screws) and the central vertical cover (5
screws). Remove the two countersunk screws (1 each
side) securing the grill hinge arms to the front of the
grill chamber.
Note: The arms are spring tensioned. Carefully remove
the grill door. Retain the gaskets.
Reassemble in reverse order, ensuring that the gasket is
tted between the hinge arm and the front of the grill
chamber.
ArtNo.320-0001 Door hinges
1
ArtNo.320-0001 Door hinges
2
Fig.9-9 Fig.9-10
ArtNo.321-0007 - MF oven element 1
A
ArtNo.321-0008 - MF oven element 2
B
Element fixing screws
ArtNo.321-0005 Fan oven element
Fig.9-6
Fig.9-8
Fig.9-7