Kalorik JK 39380 Hot Beverage Maker User Manual


 
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only
what is inside the frame.
6 JK 39380 - 131101
Assembly page 6/24
Fax +1 305 430 9692
When pouring a large quantity of hot water, pour slowly and do
not incline the kettle past the horizontal line to avoid burns and
injuries.
SAFETY CUT-OUT
This cordless water kettle is protected with an automatic safety
device, if accidentally switched on without water. Please bear in
mind that only the thermostat is switched off in case of overheat,
whereas the switch stays in the ON-position.
If this happens, switch off the appliance by putting the switch in
the OFF position and wait about 10 minutes for the element to
cool. Then pour in sufficient cold water to cover the element. This
will reset the safety device.
The kettle may then be used as normal.
CLEANING AND MAINTENANCE
Before attempting any cleaning operation, make sure the
appliance is unplugged from the supply socket and fully cooled
down.
To clean the exterior surfaces, simply wipe over with a soft, damp
cloth and dry thoroughly.
Never use abrasive products, powders or scouring pads.
Under no circumstances shall the jug kettle or its power base be
immersed in water.
To remove mineral deposits from the water kettle, use products
(decalcifying solutions) made especially available for this
purpose. Make sure to use a type recommended for kettles or
coffee makers. Follow the guidelines as recommended by the
manufacturer of the de-calcifying solution. Rinse well.
FILTER
Your appliance is provided with a mesh filter. This filter is factory
pre-installed before the spout.
The filter is placed in front of the spout. Filter should be rinsed
clean regularly. For this, press the filter out, rinse under water, and
put it back into position once clean.