Kalorik JK 39825 Hot Beverage Maker User Manual


 
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only
what is inside the frame,
5 USK JK 39825 - 120501
Assembly page 5/24
Fax +32 2 359 95 50
BEFORE THE FIRST OPERATION
For the perfect taste, operate the jug kettle with fresh water in order
to clean any residue left from the manufacturing process. When the
appliance has cooled down, repeat the process 3 times with fresh
water, before rinsing.
OPERATION
Always remove the jug from the power base before filling it or
before any operation.
Raise the lid and fill the tank with fresh water paying attention not
to fill under the minimum mark or above the maximum mark in
the kettle.
Release the lid and make sure it closes correctly.
Put the jug onto the power base, plug into the wall socket and
switch on. The pilot light of the switch will come on, indicating
that the appliance is operating. If it does not come on, check if
the kettle is correctly positioned on the base and check if the
base is plugged in.
The jug kettle will switch off automatically when the water has
boiled. However, you can stop the appliance any time by putting
the switch in the off position.
For instant reboiling, wait until water has cooled down and switch
on the appliance again.
SAFETY CUT-OUT
This jug kettle is protected with an automatic safety device if
accidentally switched on without water. Please bear in mind that
only the thermostat is switched off in case of overheat, whereas
the switch stays in ON-position.
In this case, switch off the appliance by putting the switch in OFF
position and wait about 10 minutes for the element to cool. Then
pour in sufficient cold water to cover the element. This will reset
the safety device.
The kettle may then be used as normal.