Filter
Top Products
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only
what is inside the frame,
6 BL 16909 / 16911 - 120501
Assembly page 6/28
Fax +32 2 359 95 50
ASSEMBLY OF THE BLENDER AND USE
CAUTION!
If the blade is disassembled from the bottom of the jar, check the
cleaning section for mounting instructions before continuing.
• Put pouring jar on the motor block and make sure it is correctly
inserted.
• Remove the lid of the blender.
• Fill the pouring jar with the chosen ingredients.
• Close the lid.
• Plug in the appliance.
• Choose the mixing speed with the button on the motor base. The
position 0 corresponds to the stopping of the appliance, the
position 1 to the slow speed and the position 2 to the fast one.
• The position "P" (Pulse) is particular because the button has to be
kept manually. This position is generally used to crush ice in order
to avoid damages on the blades, but it can also be used to
complete the mixing.
• It is also possible to add liquids or other ingredients anytime
without stopping the appliance. You only have to remove the
cap, which closes the feeding opening by turning and raising it
straight up.
• Once you have finished the preparation, stop the appliance
(position 0) and unplug the appliance.
• Remove the jar from the base. Then remove the lid and pour the
liquid in the desired receptacle.
IMPORTANT: When mixing hot liquid, do not fill more than 1/3 of the
jar and be very careful in order to avoid splashing of hot liquid,
otherwise you can get burned. Add the hot liquid to mix
progressively, without ever overfilling (never more than 1/3 of the
volume), and do not close the feeding hole of the pouring jar with
the cap, so that there will be no steam build-up that might have the
hot liquid erupt out of the jar when the blender is turned on. Always
wear protection mitts to manipulate the blender with hot liquids.