Filter
Top Products
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
Fax +32 2 359 95 50
MANUAL OPERATION
• Slide the release / open button of the lid of the water tank and lift
the lid open. Fill the water tank with cold water. The number of
cups can be read on the graduated water tank. Close the lid.
• Pull the filter holder out using its handle, fill the permanent filter
with the desired quantity of ground coffee or use the grinder (see
“USING THE COFFEE GRINDER” section). Then replace the filter
holder in its initial position.
NOTE: If you do not want to use the grinder and decide to fill the
filter with normal ground coffee, press the GRIND OFF button, the
orange pilot light will come on.
NOTE: You cannot switch this “GRIND OFF” function on or off if the
on/off light (Red), or the timer light (Green) are already lighted.
• Make sure the jug is placed correctly on the hotplate.
• To switch on your appliance, press once the ON/OFF switch. The
red pilot light will come on and the coffee will start flowing after a
few seconds.
When you remove the jug from the appliance, a non-drip valve
will automatically operate to stop any drops of coffee dripping
onto the hotplate. Replacement of the jug automatically opens
the non-drip valve and allows remaining coffee to filter trough
into the jug.
•
• Once the water tank is empty, we advise you to wait until the
brewing process is finished and the filter has run empty before
removing the jug.
• You can switch off your appliance anytime simply by pressing the
ON/OFF switch until all pilot lights are off.
10 USK CCG 19322 - 080626
Assembly page 10/32