Filter
Top Products
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only
what is inside the frame.
6 USK CM 17442 – CM 32764 - 110127
Assembly page 6/24
Fax +32 2 359 95 50
CAUTION: Do not touch the lid of the filter holder during
or just after use as this part becomes very hot. Use the
small lug located on the lid for this purpose (see picture).
DESCALING AND CLEANING
• Descaling the coffee maker prolongs its life span. For
decalcification only use products especially made for descaling
of coffee makers and follow their instruction manual carefully. Do
not use vinegar for descaling. Descale the coffee maker as soon
as you notice longer brewing times.
• Never put any part of the appliance in the dishwasher. Clean the
jug with soapy water and rinse it with clear water.
• To clean the plastic parts of the appliance, use a humid, non
abrasive cloth.
PRACTICAL HINTS
• When you notice that the coffee making process is longer than it
should be, or excessive steam is produced by the coffee maker,
it is probably time to decalcify the appliance. Do not wait for the
situation to get worse. The frequency depends on the amount of
lime in water and therefore can be different from a household to
another. A good maintenance of your appliance will prolong its
lifespan. Guarantee claims will not be accepted for the
replacement of a heating element full of limescale.
• Make sure to position the water tank correctly to avoid excessive
steam. It should be seated perfectly in place to enable to fully
open the water admission valve. Press lightly on the top of the
tank when putting in place and close the lid above the water
tank during operation.
• Be careful to position the filter holder well. There are 3 arrow-
shaped triangles routed on the filter holder which belong under
the shower that dispenses the hot water. There is only one way to
position the filter holder, else the upper lid will not close. The
upper lid needs to be closed completely in order to avoid
excessive steam escaping from the sides. To remove the filter
holder, please use the handle that can be raised through its lug.
• Never open the upper lid while brewing as the shower might
spray scalding hot water on you, if raised while dispensing the
water.