Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only
what is inside the frame.
6 USK CM 25282 - 110127
Assembly page 6/20
Fax +32 2 359 95 50
• Wait until the brewing process is finished and the filter is empty
before removing the jug.
• Practical hints: When the water tank is empty, wait a few more
minutes, as some water might still drip out of the filter before
removing the jug.
• Note: a 2-hour auto-shut off feature is activated when operating
the coffee maker manually
PROGRAMMING THE COFFEE MAKER
• To program your coffee maker to brew fresh coffee at a preset
time, first follow steps 1 to 4 in the “PREPARATION OF COFFEE”
section.
• Make sure the coffee maker’s clock is set to the right time.
• Press the PROGRAM button twice. The clock will now display 12:00
with the word “TIMER” in the upper left corner. Use the HOUR and
MINUTE buttons to set the desired brew time.
• Press the START/STOP button twice to activate the preset brew
cycle. The green AUTO light will illuminate when the brew time is
properly set.
• When your preset brew time is reached and the coffee maker
starts its brew cycle, the green AUTO light will go out and the red
ON light will illuminate.
• As with the regular brew cycle, an automatic two hour keep
warm cycle will commence after your coffee maker has finished
brewing. At the end of the two hours, the coffee maker will
automatically shut itself off.
NOTE: the 2-hour auto-shut off feature will also be activated when
operating the coffee maker manually