Kalorik USK ICBM 30155 Ice Maker User Manual


 
5 USK ICBM 30116/30155 - 090716
OPERATION
After having unpacked the appliance, clean water tank and ice
basket thoroughly. Wait for 2 hours before taking the next step.
Pour drinkable water in the water tank. Do not try to fill more than
50 Oz. water or above the level of the ice basket.
To select the size of the ice cubes, press the SELECT button until
the corresponding pilot light turns on. “S”: small, or “L”: large.
Press START button to start the ice making process.
If the water tank is getting empty, the “ADD WATER” pilot light will
turn on and a long beep will sound. In that case, the compressor
will stop automatically. Remove the ice basket, refill the water
tank. Wait for 3 mn after the beep sound before pressing the
START button to resume the ice making process.
When the “ICE FULL” pilot light switches on, a beep will sound; it
means that you should empty the ice basket. In that case, the
compressor will stop automatically. Empty the ice basket
completely or partially. Wait for 3 mn after the beep sound before
pressing the START button to resume the ice making process.
You can stop the ice making process at any time by pressing the
STOP button, to switch off the appliance.
Do not leave the ice maker non working for a long period of time,
as the water could get stale and improper for consumption. If you
do, please refer to the “Cleaning and Care” section of this user
manual.
NOTES:
If the ambient temperature is below 15°C/60°F, we advise you
to select the small size. If the ambient temperature is higher
than 29°C/85°F, we recommend you select the large size.
For best performance, the temperature of the water you pour
into the water tank should be between 7°C/45°F and
25°C/75°F and the ambient temperature between 15°C/60°F
and 37°F/100°F.
If you select the large size, the ice making process will be a
little bit longer.
You must press “START” button to restart the ice maker after
you add water or take out some of the ice after a warning
signal. If you do not, the compressor will automatically restart