Filter
Top Products
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only
what is inside the frame.
5 USK JK 20744 JK 32762 - 110127
Assembly page 5/24
Fax +32 2 359 95 50
OPERATION
•
Always remove the jug from the power base before filling it or
before any operation.
•
Open the lid by pressing its release button and fill the tank with
fresh water, paying attention not to fill under the minimum mark
and above the maximum mark on the water level indicator.
•
Close the lid by pressing it down until it you hear a click. Make
sure it closes correctly.
•
Make sure the spout filter is well in position, as else the auto-shut
off feature would not work.
•
Put the jug onto the power base, plug into the wall socket and
switch on by pressing down the switch situated on the handle. The
blue pilot light comes on indicating the appliance is operating.
•
The jug kettle will switch off automatically when the water has
boiled. However, you can stop the jug kettle anytime by putting
the switch in off position.
•
For instant re-boiling, wait until water has cooled down and
switch on the appliance again.
SAFETY CUT-OUT
•
This jug kettle is protected with an automatic safety device if
accidentally switched on without water. Please bear in mind that
only the thermostat is switched off in case of overheat, whereas
the switch stays in ON-position.
•
In this case, switch off the appliance by putting the switch in OFF
position and wait about 10 minutes for the element to cool. Then
pour in sufficient cold water to cover the element. This will reset
the safety device.
•
The kettle may then be used as normal.