Filter
Top Products
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity. Print only what is inside the frame.
7 WCL 32964 - 111026
Assembly page 7/28
Fax +32 2 359 95 50
• The fans start turning and the wine cellar starts cooling
NOTE: The inside temperature of the thermoelectric wine cooler
depends on the room temperature. To reach the minimum
temperatures indicated below, it should be located in a room whose
temperature is maximum 75°F / 25ºC.
Temperature control and display
The upper zone of the appliance is for storage of white wine with
temperature from 45°F to 54°F (7°C to 12°C) The lower zone is for
storage of red wine with temperature range from 54°F to 64°F (12°C
to 18°C).
The display usually shows the average temperature of the appliance
at that moment.
Manual temperature setting
The temperature is factory preset when the cellar is off the
assembling line. If you want to change the temperature in the
cabinet, please select the right zone and change accordingly.
The temperature of the wine cooler can be set by pressing the
temperature “up” and temperature “down” buttons as follows:
1) By pressing the button C/F on the control panel, select if you
want to display the temperature in Fahrenheit (F) or Celsius (C).
The temperatures in Fahrenheit are always the highest value.
2) There are four buttons on the panel: on the left, push “UP” to
increase the temperature or push “DOWN” to decrease the
temperature in upper zone. On the right, push “UP” to increase
the temperature or push “DOWN” to decrease the temperature
in lower zone.
3) When the power switch is connected, cooling system starts to
work. The temperature is set on certain temperature level, which
means that when the inner temperature reaches the set point,
the appliance will stop cooling, so that the temperature in the
cabinet rises gradually.
4) When the inside temperature rises above the set point, cooling