Filter
Top Products
7
Operating Instructions
Before First Use
Remove any packaging material and
promotional labels before using your
kettle for the first time.
It is recommended before the first use
to fill the kettle to the maximum level
with cold tap water, bring to the boil
and then discard the water. Your kettle
will only operate when positioned
on the power base with the ON/OFF
switch in the ‘ON’ position. The kettle
will automatically switch off once the
water has boiled.
Operation Of Your Kettle
1. To fill the kettle with water, remove it
from the power base and open the
lid by pressing the button on the lid
of the kettle and lifting it upwards.
Fill with the desired amount of
water. Do not operate the kettle
without water. Always fill the kettle
between the minimum and the
maximum marks on the water
window. Too little water will result in
the kettle switching off.
2. Ensure that the lid is closed and
locked firmly into place before
placing the kettle on the power
base.
3. Place the kettle firmly onto the
power base. Plug the power cord
into a 230V or 240V power outlet
and switch ‘ON’.
4. Press the ON/OFF switch to the ‘ON’
position. The power ‘ON’ light will
illuminate.
NOTE: Never operate the kettle
dry - too little water will result in the
kettle switching ‘OFF’.
Do not overfill the kettle - filling
above the maximum mark on the
water window may result in boiling
water splashing from the kettle.
NOTE: This kettle must only
be used with the power base
supplied. Use caution when
pouring water from your kettle,
as boiling water will scald. Do
not pour the water too quickly.
NOTE: Do not remove the kettle
from the power base during
operation. Ensure the kettle has
switched to the ‘OFF’ position
after the water has boiled
before removing the kettle from
the power base.
5. The kettle will automatically switch
‘OFF’ once the water has boiled. Lift
the kettle from the power base and
pour the water. Take care to hold
the kettle level, especially when
filled to the maximum level. To re-
boil it may be necessary to wait for
a few seconds to allow the control
to reset.
The kettle should be stored on its
power base when not in use. The
power outlet should be switched off
and the power cord unplugged from
the power outlet when not in use.