Filter
Top Products
Using Your
Kambrook Elite Kettle
Before first use of your new Kambrook
Elite Kettle, clean the element and internal
section of the container by boiling the
kettle full, following the instructions
below, and then discard water.
NOTE! The Kambrook Elite Kettle must only be
used with the power base supplied.
To fill the kettle, open the lid by pulling up
on the handle on the lid.
Fig 1
Fill the kettle to the desired level of water.
Do not fill above the max water level line
or below the minimum water level line
marked on the water window.
Do not over fill the kettle as this may
result in boiling water being splashed out
and too little water will result in the
kettle switching off bef
or
e the water has
boiled.
Place the power base on a level, flat,
surface. Plug into a 230/240V power
outlet and switch on.
Ensure that the lid is locked firmly in place
and then place the kettle securely onto
the power base.
Push the On/Off switch down.The 'on'
light will illuminate indicating that the
kettle is boiling water.
Once the water is boiled the kettle will
automatically switch off.
Switch off at the power outlet and then
lift the kettle from the power base and
pour as required using the handle.
Ensure that the power is switched off at
the power outlet when the kettle is not in
use.
The kettle may be stored on the power
base when not in use.
CAUTION: Do not operate on an
inclined surface. Do not operate
unless the element is fully
immersed. Do not move while
switched on.
Failure to observe these cautions
may result in damage to the kettle.
NOTE! Use caution when pouring water from
your kettle, as boiling water will scald. Do not
pour the water too quickly.
4