Filter
Top Products
4
Using Your Kambrook Mega
Blend
Before first use remove any promotional
labels and wash the blender jug and lid in
warm, soapy water, then dry.
Place the blender motor base on a level,
flat surface.
Place the empty jug onto the base
Place food or liquid into the jug and firmly
push the lid on top of the jug.
Ensure the speed dial is in the Off
(
O
)
position.
Plug into a 230/240-volt power outlet.
Turn power outlet on.
When switching the unit on hold the lid
down to ensure it is safely in place.
To begin blending move the speed dial from
the Off
(
O
)
position to either the Low
(
1
)
or High
(
2
)
speed, depending upon mixing
requirements.The speed can be changed at
any time during the blending process.
When blending is complete, turn blender
off by moving the speed dial to the Off
(
O
)
position.Wait until blades have stopped
rotating before removing the lid or the
blender jug from the base.
Use the PULSE setting for ingredients that
require short bursts of power.
Hold the speed dial on this setting until
desired blending is achieved.When released,
the speed dial will automaticall
y return to
the Off
(
O
)
position.
If ingredients stick to the sides of the
blender jug during the blending process,
turn the speed to the Off
(
O
)
position,
switch off and unplug from the power
outlet, then push the food back onto the
blades using a plastic spatula to scrape
down the sides of the jug.Then
recommence blending.
NOTE: If any moisture or liquid appears on top of
the motor base, wipe immediately with paper
towelling
NOTE:When blending liquids a small amount of
liquid may come up from around the filter cap.This
is normal.
Ensure that the filter cap is correctly in
place BEFORE blending. Once blending
has commenced (ie/ dial is in a position
1 or 2) you may remove the filler cap
and add additional ingredients.
NOTE: Ensure that the maximum level is not
exceeded.
Correctly fitting the filler cap
Align the protruding nubs on the filler cap
with the indents on the lid and push
through.Turn the cap clockwise until fully
locked into position ie/ the cap can not be
turned any further and the tabs are
hidden under the white of the lid.
NEVER PLACE ANYTHING OTHER
THAN FOOD AND LIQUIDS IN THE
MEGA BLEND WHILST THE MOTOR IS
RUNNING.
DO NOT PROCESS BOILING OR
HOT LIQUIDS OR INGREDIENTS, LET
THEM COOL BEFORE PLACING INTO
THE JUG.