Filter
Top Products
7
Using Your Blender
Before First Use
Before using your Kambrook Blender
for the first time, remove all packaging
material and promotional labels.
Ensure the appliance is switched off
at the power outlet and power cord
is unplugged.
Wash the lid, inner cap and blender
jug in warm soapy water with a soft
cloth. Rinse and dry thoroughly (refer
to care and cleaning instructions).
The motor base can be wiped with a
damp cloth. Dry thoroughly.
Assembling/Operating Your
Kambrook Blender
1. Place the power cord through
the cord slot and place the motor
base on a flat, dry surface. Ensure
that the blender is switched off at
the power outlet and the power
plug is unplugged from the
power outlet.
2. Place the blender jug onto the
motor base. Ensure that the
blender jug is securely positioned.
3. Add food or liquid to the blender
jug. Place the lid on the blender,
and push down to seal. Insert the
inner cap into the hole of the
blender jug lid.
4. Plug the power cord into a 230V
or 240V power outlet and switch
on at the power point.
5. Turn the speed control dial
clockwise for the speeds Low and
High setting and counterclockwise
for Pulse Setting. The speed can
be changed at any time during
the blending process. Ideally, start
blending on ‘LOW’ speed and
then increase to a ‘HIGH’ speed
if necessary to blend until desired
consistency is reached. For
ingredients that require short burst
of power, use the pulse speed. This
is ideal for thick liquids, ice or nuts.
6. To stop the blending at any
time, turn the speed control dial
to ‘OFF’.
7. After use, ensure the blender
is switched off by turning the
speed control dial to the ‘OFF’
position, then switch off at the
power outlet and remove the
power cord. Allow the blender to
cool before storing.
NOTE: During the blending
process, ingredients may stick
to the sides of the blender jug.
To push the food back on the
blades, turn the speed control
dial to ‘OFF’ and switch the
power off at the power outlet
and remove the power cord.
Remove the lid and use a
plastic spatula to scrape
down the sides of the
jug. Replace lid before
recommencing blending.
NOTE: If the blades become
stuck, immediately select the
speed control dial to ‘OFF’
and switch the power off at the
power outlet and remove the
power cord. Remove the jug
from the blender base and
remove the lid. Use a plastic
spatula to dislodge the food
or liquid from the blades.
Replace lid before
recommencing blending.
KBL110_KBL210_IB_FA.indd 7 16/11/09 2:45 PM