Filter
Top Products
8
Using Your Snugasabug
®
Fitted
Electric Blanket continued
To Detach The Controller
The socket has a locking clip that
engages with a small pin on the plug.
Ensure the electric blanket controller
is in the ‘OFF’ position and not
connected to the 230V or 240V power
supply.
With the controller set to the ‘OFF’
position, push the clip out to release
the socket pin and withdraw the
connector plug by pulling it away
from the socket.
Storing Your Control Unit
Remove the controller when
laundering your blanket. Store your
controller during summer months
while your blanket remains on the bed
as a comfortable underblanket.
Dual Control Units
Your Double/Queen and King size
electric blanket features two controls
for individual comfort.
Turning Your Fitted Electric
Blanket On
Ensure the electric blanket controller
is positioned in the ‘OFF’ position
indicated by an ‘0’.
Plug the cord in a 230V or 240V power
outlet and switch the power on.
Ensure to pass the controller and
wiring through the apertures in the
skirt section of the blanket.
Ensure that when the blanket is fitted
onto the mattress the controller/s and
flexible power supply are outside of
the bed and coverings and located in
a position that will prevent accidental
damage to the housing and cords.
Use this blanket only as an under
blanket and do not use above the
occupant of the bed.
Fixing The Removable Cover
(Only KEB512, KEB532 and
KEB542 models)
When fixing the removable cover in
position ensure the fleecy side of the
cover is on the uppermost side. Secure
the removable cover using the studs
fastened over the complete cover.
There should be no rucking of the
removable cover when the studs are
completely fastened.
No other cover other than that
supplied with the blanket should be
used with the electric blanket.
To Connect The Controller
Your blanket has a detachable
controller and waterproof element
which makes your blanket machine
washable.
Ensure the electric blanket controller
is in the ‘OFF’ position and not
connected to the 230V or 240V power
supply.
To connect your controller, thread the
detachable plug from the controller
through the slot in the mesh skirt and
plug it fully into the socket.
Ensure that the locking clip engages
with the small plastic pin on the plug.
Turn the electric blanket over, position
and fit it to the mattress.
KEB412_IB_FA.indd 8 14/10/09 1:26 PM