Filter
Top Products
$ig sal " °
, ,un,,
Water Heating
The Water Heating fight glows to indicate the dish-
washer is heating water to the proper
dishwashing temperature if your
household water is not hot enough
NOTE: The electronic time display
will pause whife this occurs°
o All cycles (except Quick Rinse)
automatically heat water during the final rinse.
Water heating is automatic in the wash portions
of the Pots Pane cycle,
Water heating is an option inthe main wash of the
Norma! Wash and Water Miser cycles,
Sani Complete
The Sani Complete light glows at the end of the
cycle indicating a high temperature,
sanitary rinse was completed°
NOTE: A flashing Sani Complete light
indicates that a high temperature, sani-
tary rinse was not completed, The Sani
Complete light will flash at the end of
the cycle if the dishwasher door is opened, power
fails, or water heating is not completed during the
final rinse. You may need to turn your water heater
temperature up so water is at least 120°F (49°C) as
it enters the dishwasher.
#etaj £atasi l®ast
................... lU,
Use Delay Wash when you want a cycle to start
later, Delay Wash can be set to start
the dishwasher during times when
off-peak utility rates are in effect or
when you are away from home
'1. Close the door firmly until you hear it latch..
2. Press the Delay Wash pad and one hour of delay
will show on the display. Each time
you press the Delay Wash pad, the
delay time will increase in one-hour
settings,, The longest delay setting
is 9 hours.,
Hours of delay
3. Press pads for desired cycle and options.
i Ul,, ii,,,,ll
In addition to showing remaining delay or cycle
time, the digital display will show a code indicating
the dishwasher's condition:
° PF will appear in the display the first time the
dishwasher isconnected to the elec-
trical supply after inetallation_ This
display also indicates there was a
power failure. Press Cancel/Drain to
drain the dishwasher. If there is no water in the
dishwasher, press Cancel/Drain a second time,
Reselect a cycle to restart the dishwasher.
4_ The display will show the number of hours remain-
ing until washing begins. The display will show
hours only: If the display shows 2, there is be-
tween 1 hour and 1 hour 59 minutes remaining.,
& When the hours of delay you have set have
elapsed, the dishwasher will start the cycle se-
lected in Step 3oThe wash time wi!l count down
the minutes remaining in the cycle to O.
If you wish to put more dishes in the dishwasher
while it is in the delay mode, be sure to latch the door
after adding them The timer wil! not advance unless
the door is latched. To cancel Delay Wash, press the
CanceVDrain pad.
° CC will appear on the display when the dishes are
washed and the cycle completed,
Opening the door or pressing the
Cancel/Drain pad wifl dear the display.
E2 witl appear in the display if the selector pads are
stuck. Press CanceVDrain to release
the controls, or run your fingers across
the pads to free them up. If E2 remains
in the display, call for service.
10