Filter
Top Products
ThisUse&CareGuideprovidesspecificoperating
instructionsforyourmodel.Usethefreezeronlyas
instructedinthisUse&CareGuide.Beforestartingthe
freezer,followtheseimportant first steps.
iNSTALLATiON
• Choose a place that is near a grounded electrical
outlet. Do Not use an extension cord or an adapter
plug.
• For the most efficient operation, the freezer should
be located where surrounding temperatures will not
exceed 110°F (43°C). Temperatures of 32°F (0°C) and
below will NOT affect freezer operation. Additional
compressor heaters are not recommended.
• Allow space around the unit for good air circulation.
Leave a 3 inch (75 mm) space on all sides of the
freezer for adequate circulation.
3=(75turn)AirSpace
(25ram)
Installation
3" (75rnm)
Installation
NOTE: The exterior walls of the freezer may become quite
warm as the compressor works to transfer heat from the
inside. Temperatures as much as 30° F warmer than room
temperature can be expected. For this reason it is particu-
larly important in hotter climates to allow enough space for
air circulation around your freezer.
LEVELING
The freezer must have all bottom corners resting firmly on
a solid floor. The floor must be strong enough to support
a fully loaded freezer. NOTE: It is VERY iMPORTANT for
your freezer to be level in order to function properly. Ifthe
freezer is not leveled during installation, the door may be
misaligned and not close or seal properly, causing cooling,
frost, or moisture problems.
To Level Upright Models:
After discarding crating screws and wood base, use a car-
penter's level to level the freezer from front-to-back. Adjust
the plastic leveling feet in front, r/2bubble higher, so that
the door closes easily when left halfway open.
Plastic
Leveling Feet
Crating
Screw
"". Discard Th Crating ecrews
And (2) Wood Bases
-.%
Unpacking and Leveling -- Upright Models
To Level Chest Models:
If needed, add metal or wood shims between foot pads
and floor.
CLEANING (PRIOR TO USE)
Wash any removable parts, the freezer interior, and
exterior with mild detergent and warm water. Wipe dry.
Do not use harsh cleaners on these surfaces.
• Do not use razor blades or other sharp instruments,
which can scratch the appliance surface when
removing adhesive labels. Any glue left from the tape
can be removed with a mixture of warm water and mild
detergent, or touch the residue with the sticky side
of tape already removed. Do not remove the serial
plate.
_To allow door to
close and seal properly, DO NOT let
food packages extend past the front
of shelves.
Shelf Front