Filter
Top Products
iCE AND WATER DISPENSER FEATURES
The ice and water dispenser convenbntUy dispenses chHbd water, and ice cubes or crushed ice, depending on the model
Tooperate the ice dispenser, sebct the ice option desired using the touchpad. Press a gUassagainst the dispensing paddb
as far up as possibb to catch aHice. To stop dispensing ice, pull gUassaway from dispensing paddb. Do not remove the
gUassuntil the ice has compbteUy dispensed. (Compbte instructions for the dispenser operation are attached to the inside
of the freezer door.)
The ice maker produces 4 to 6 pounds of ice every 24 hours depending on usage conditions, ice is produced at a rate of 8
cubes every 75 to 90 minutes.
How the Water Dispenser Works
The water tank located behind the drawers in the refrigerator compartment, automatically fills as water is dispensed. For
proper dispenser operation, the recommended supply water pressure should fall between 20 psi and 100 psi,
Water pressure must not exceed !00 Ibs,Excessive pressure may cause water filter to malfunction,
After the refrigerator is connected to the water supply, fill the water tank by drawing one glass of water, it may take about
11/2minutes after activating the dispenser paddle before water begins to fill this first glass. Continue flushing the system
for 3 minutes to rid the tank and plumbing connections of any impurities. The water dispenser has a built in shutoff device
that will stop the water flow after 3 minutes of continuous use. Simply release the dispenser paddle to reset the shutoff
mechanism.
Chemicals from amaffunctioning softener can damage the ice maker. If the ice maker is connected
to soft water, ensure that the softener is mai rltained and working properly.
How the ice Dispenser Works
The ice maker and container are located in the top of the freezer compartment. After the
refrigerator is installed properly and has cooled for several hours, the ice maker can begin
making ice within 24 hours. Air in new plumbing lines may cause the ice maker to cycle two
or three times before making a full tray of ice. ice production is controlled by the ice
maker's On/Off power switch. Press the switch to the "0" position to turn it Off and press it
to the '1"position to turn it On. With no usage it will take approximately 2 days to fill the ice
container. The ice maker also has a built-in wire signal arm,which automatically stops ice
production when the ice bin isfull. This signal arm should not be used to manually stop the
ice maker.
Because of new plumbing connections, the first production of ice cubes may be discolored
or have an odd flavor, These should be discarded until the cubes made are free of discoloration and taste,
iCE DISPENSER TiPS
ice cubes stored too long may develop an odd flavor. Empty the ice container and ensure that the ice maker's On/Off
power switch is turned On (set to the '1" position). The ice maker will then produce more ice.
o Occasionally shake the ice container to keep ice separated.
o Keep the ice maker's On/Off power switch turned Off (set to the "0" position) until the refrigerator isconnected to the water
supply or whenever the water supply is turned off.
iMPORTANT: The ice maker !s tureed On atthe factory SOit can work as soon as you insta!!your refrigerator. If you
cannot Connect a water supply, turn theOn/Off switch tOthe Off ('{011)position_Otherwise, the ice maker's valve
may be n°isY who n it attemp!s tooperate witho ut water:
the disport!!rig paddle !S pushed for more tha n 4 m!nutes, the dispenser motor may ovedoad
and stop.The overload protector will reset automatically after 3 or 4 minutes.
14