Kenmore 2535629340N Refrigerator User Manual


 
Deer Removal Instructions
ToolsNecessar,
Phi liras nec__:
TO DiSCON_,ECT
1.Press outerring a_alr _t_ace
remove JuDe
TO CONNECT
Insert tube and
uush until mark touches face of fi_th
DOOR REMOVAL mNSTRUCTIONS:
If it is necessary to move the refrigerator through narrow doorways,
follow these steps to remove the doors.
IMPORTANT: Before you begin, turn Freezerand Fresh Foodcontrob
to 0 and remove ebctrbaI power cord from wall outbt. Remove any
food from door shelves.
1. Disconnect electrical supply.
2. 0 pen both doors, then remove toe grille.
3. Close doors.
To Remove Refrigerator Door:
1 Remove top hinge cover screw on refrigerator door and remove cover.
2. Trace around hinge with soft lead pencil. This will make it easier to realign
doors when they are replaced
3. Remove top hinge and lift refrigerator door off bottom hinge pro. Set door
aside.
4. Remove bottom hinge, if necessary.
5. Reverse this procedure to reinstall refrigerator door.
To Remove Freezer Door:
1. Disconnect water line coming [rom lower hinge of freezer door at connection
located under front of freezer: Press outer ring against face of fitting, then puii
to remove tube.
2. Remove top hinge cover screw on freezer door and remove cover.
3. Disconnect wiring harness connector plug at top hinge: place your thumbs on
fiat sides of each connector and bend both parts back and forth. Ihen with
firm grasp, puii both pieces apart.
4. Trace around hinge with soft lead pencil. This wiii make it easier to realign
doors when they are replaced
5. Remove top hinge,allowing wiring harness to puii through hinge and lift freezer
door offof bottom hinge pin.Lay door down fiat toavoid kinking water line.
6. Remove bottom hinge, if necessary.
7. Reverse this procedure to reinstall freezer door.
When both doors have been reinstalled, connect water line by inserting tube and
push until mark touches face of fitting, replace toe grille and plug in electrical power
cord. Turn both temperature controls to center position. Adjust settings as necessary.
Nmge
A_ser_Ibky
Sc_ew_