Filter
Top Products
Door Removal and Reversal Instructions (continued)
NOTE: Some models have "pocket" handles, which are recessed into the sides of the door. On these models, only
the hinges will need to be reversed,
TO REMOVE FREEZER HANDLE:
,HandUes may be easier to reverse while doors are off,_
1. Remove two screws attaching handUeto bottom of freezer door,
2. Swing bottom of handUeaway from the door and slide handUestraight
up and off of dovetail button.
3. Remove screw and dovetail button and install on other side. moving
hole plugs from corresponding holes to opposite side.
TO ATTACH FREEZER HANDLE:
1. Start with handle offset away from door. Place top of handle over
dovetail button, swing handle into an upright position and puii
downward, locking it into place
2. Secure bottom of handle with two screws removed earlier.
f
ButtonJ
PDg /
j,
oveu
DovetailButton
TRIM REMOVAL (FULL-LENGTH TRIM MODELS ONLY}
Unsome modeUs, the refrigerator door has a full Uengthtrim piece which continues from the bottom of the handUeto the
bottom of the door, The top of the trim fits around the base of the handle, An adhesive "trim lock" is positioned about
halfway down. The bottom of the trim is held in place by either an adhesive trim lock, or a trim lock with two prongs
inserted into a hole on the face of the door.
TO REMOVE TRmM:
1. Remove trim by gently pulling trim lock areas out and away from door.
2 When trim is free from door, slide the trim straight down and away from base of handle.
TO REMOVE REFRIGERATOR HANDLE:
(Handles may be easier to reverse while doors are off.)
1. Remove two screws attaching handle to top of refrigerator door.
2. Swing top of handle away from door and slide handle down and off of
dovetail button.
3. Remove screw and dovetail button and install on other side, moving
hole plugs from corresponding holes to opposite side.
TO ATTACH REFRIGERATOR HANDLE:
1. Start with handle offset away from door. Place bottom of handle over
dovetail button, swing handle into an upright position and pull upward,
locking it into place.
2. Secure top of handle with screws.
TO ATTACH TRIM:
1. Slide both trim locks out of trim.
2. Insert new adhesive trim locks contained in your literature pack.
two donut shaped areas.
3. Install trim to handle by sliding over base of handle. Carefully align
trim and press down at trim lock locations.
4. Replace hole plug on opposite side. Use rubbing alcohol to remove
any adhesive residue from old trim lock locations.
Lock Handle
-Hand,e over
t Doveta!!
ton
oovoto,
Trim