Filter
Top Products
Setting Surface Controls
Sizes of the Surface Gas
Burners
Your appliance is supplied with
the different surface gas burners:
Burner Cap
Simmer Burner (5,000 BTU)
1 (or 2 on 36" models)
Standard Burners (9,500 BTU)
1 Power Burner (12,200 BTU or
14,200 BTU)
1 Power Burner (16,200 BTU)
or Dual Burner (18,000 BTU)
When setting up the cooktop for
the first time, make sure that the
correct Burner Heads, Burner
Caps and Burner Grates are
located as shown in Figure 1.
Burner
Extra Large
"POWER"
Burner Head Left Rear (9,500
(12,200 BTU or )Gas Opening
14,200 BTU)
Left Front
Center
Gas Opening Gas Opening
_a nner & Outer
Burner Caps
I Burner Head
(18,000 BTU)
Right Front
Gas OpeningS/
_, Right Front Gas
_, Opening
_. Burner
Dual Burner Skirt
_ on Models 790.3248
"_790.3249 only
36" Models only
Burner Cap
(Standard)
Models only
Burner Cap
_Burner Head
(5,000BTU)
Right Rear
Gas Opening
Burner
Head (16,200 BTU)
Right Front
Opening
Figure 1
Burner
Grate
Burner
Cap
Burner
Head
Figure 2
Electrode must be
located properly in
slot of each Burner
Head
Assembly of the Surface Burner Heads, Burner Caps,
Burner Grates
It is very important to make sure that all of the Surface Burner Heads,
Surface Burner Caps and Surface Burner Grates are installed correctly
and at the correct locations.
1. Place all 4 (four) or 5 (five) Burner Heads in the correct locations
(See Figure 1). Make sure that the correct Burner Head is placed
with the corresponding Gas opening and that the Electrode is
located properly in the slot of each Burner Head (See Figure 2).
Proper Burner Head placement insures that each Burner will have
the correct spark required for surface gas ignition.
2. Place the correct Burner Caps at each of the burner locations. Each
of the Burner Heads MUST have a Burner Cap installed to insure
proper ignition and gas flame size (See Figure 2).
3. Place the 2 (two) or 3 (three) cast iron Burner Grates supplied with
the range. Carefully lift the burners grates on to the cooktop over
the burners. Properly installed Burner Grates will rest with all Grate
legs on the cooktop.
REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS
OPENING. Always keep the Burner Caps and Burner Heads in place
whenever the surface burners are in use.
7