Filter
Top Products
This Owner's Guide provides specific operating instructions for
your model. Use the freezer only as instructed in this Owner's
Guide. Before starting the freezer, follow these important first
steps.
INSTALLATION
, Choose a place that is near a grounded electrical outlet. DO
NOT use an extension cord or an adapter plug.
, For most efficient operation, the freezer should be located
where surrounding temperatures will not drop below 40°F (5°C)
or exceed 110°F (43°C).
Allow the following clearances for ease of installation, proper
air circulation, and electrical connections:
Sides 3/8 inch
Back & Top 1 inch
Do not block the toe grille on the lower front of your freezer.
Sufficient air circulation is essential for the proper operation of
your freezer.
1" (25mm)
TO LEVEL FREEZER:
After discarding crating screws and wood base, use a carpenter's
level to level the freezer from front to back. Adjust the plastic
leveling feet in front, 1/2 bubble higher, so that the door closes
easily when left halfway open.
LEVELING INSTRUCTIONS FOR ALL REFRIGERATOR /
FREEZER PAIR:
, Remove two leg levelers provided in literature bag. While unit
is lying on its back for wood skid removal, install both leg
levelers in rear of unit.
, Level door of first unit using all four levelers and slide unit into
place. Recheck for levelness and adjust if necessary.
, Measure distance from floor to bottom of door on first unit.
Adjust and level second unit so door height matches.
, Leg Level Adjustments:
, One full turn of all four leg levelers will raise door 5/32".
, One full turn of both front leg levelers will raise door 3/16" and
tilt top of door back 7/16".
, One full turn of both rear leg levelers will lower door 1/32" and
tilt top of door forward 7/16".
, One full turn of both side leg levelers will raise door 3/16" and
tilt top of door 3/8".
, Slide second unit into place leaving a minimum gap of 3/16"
between units for door swing clearance.
, This last step may require at least one extraction of the second
unit to properly align units in a "built-in" application.
Lower Plastic
leveling Feet
CI_tLl_g
Screw
And (2) Wood Bases
DOOR OPENING
NOTE: If your freezer is placed with the door hinge side against
a wall, you may have to allow additional space so the door can
be opened wider.
LEVELING
The freezer must have all bottom corners resting firmly on a solid
floor. The floor must be strong enough to support a fully loaded
freezer. It is VERY iMPORTANT for your freezer to be level in
order to function properly. If the freezer is not leveled during
installation, the door may be misaligned and not close or seal
properly, causing cooling, frost or moisture problems.
Shelf
Front