Filter
Top Products
Installation Instructions
Proper installation will ensure this refrigerator operates
most efficiently.
Spacing Requirements
I WARNING
Keep flammable materials and vapors, such as
gasoline away from refrigerator
Failure to do so can result in death, explosion, fire, or
burns.
• To ensure proper ventilation for your' refrigerator, allow
for a 1" (2.5 cm) space at the top and sides of your
refrigerator,
• tf your refrigerator has an ice maker; make sure you
leave some extra space at the back to allow for the
water line connection° The refrigerator' can be flush
with the back wall if you do not have an ice maker
installed.
• If you are installing your refrigerator' next to a fixed
wall, leave 2 3/4"(7 cm) minimum on each side
(depending on your model) to allow for the door to
swing open 90 °.
tf tops of doors are not level perform the following steps:
• Determine which door must be raised (if toe grille has
not been removed, remove at this time)
• Turn front roller adjustment screw clockwise to raise
front corner of door that needs to be raised_ Roller
adjustment screw should be turned untit doors are
level.
• Replace toe grille=
raise door
adjustment screw
clockwise until
doors are level
NOTE: Do not install the refrigerator near an oven,
radiator, or other heat source, nor in a location where
the temperature will fall below 55°F (13°C)_
Stabilize refrigerator and align doors
If refrigerator rocks or is not stable on floor perform the
following:
Removing Handles
Tools Required
Putty knife (blade covered by masking tape)
s/l_" (8 mm) hex nut driver
o Determine which rear corner is rocking. /8 (9.5 mm) lex nut dnver
• Remove toe grille to gain access to roller adjustment Phillips screwdriver
screws.
• Turn rear roller adjustment screw clockwise to raise
corner that is rocking.
\
Door hinge screws
Rear roller-
adjustment
screw
Front rollerI
adjustment
screw
• Check alignment of top of doors, tf doors are level
replace toe gr ille_
Blade screwdriver
I WARNING
Disconnect power to refrigerator before removing
doors to avoid electrical shock which can cause severe
:_ersonal injury or death, After' replacing doors, connect
}owero
Some installations may require handle removal to get
the refrigerator into the home. If so, perform the
following:
o Pry up edge of handle trim using a putty knife, with the
blade end covered in masking tape_ Remove handle
from door by removing 2 mounting screws at each end
of handle.
4