Kenmore 587.15072 Dishwasher User Manual


 
Solutions to Common Dishwashing Problems
(continued)
Removing Spots and Film
Hard water can cause lime deposit buildup on the
interior of the dishwasher. Dishes and glasses may also
get spots and film for a number of reasons. (See
Glassware/Flatware Spotted or Cloudy section.) To
remove buildup, spots and film, clean using the
following instructions:
1. Load clean dishes and glasses in normal manner.
Do not load any metal utensils or silverware.
2. Do not add detergent.
3. Select the NORMAL WASH cycle. Close and latch
door. Press START/CANCEL pad.
4. Allow dishwasher to run until it starts the second
water fill (approximately 10 minutes). The
SENSING light will be off.
5. Unlatch and open door and pour 2 cups
of white vinegar into the bottom of dishwasher.
6. Close and latch door and allow cycle to finish.
Note: If these conditions persist, a home water softener
should be considered.
iii!!!iiiiiiiiiiiiiiiii
To customize your dishwasher to match your cabinets:
You will need atrim kit.
See Step 10 of Installation Instructions that came with your dishwasher for more information.
20