Filter
Top Products
Troubleshooting
Ice
Refrigerator is
leaking water
(ce forms in inlet
tube to ice maker
Water flow is
smower than normal
• Plastic tubing was used to complete
water connection.
• Improper saddle valve was installed.
• Water pressure is too low.
• Freezer temperature is too high.
• Water pressure is too low.
• Improper saddle valve was installed.
• Copper tubing has kinks.
The manufacturer recommends using copper tubing
for installation. Plastic is less durable and can cause
leakage. Sears is not responsible for property
damage due to improper installation or water
connection.
Check water connection procedure (see page 12).
Self-piercing and 3/,_..saddle valves cause low water
pressure and may clog the line over time. Sears is
not responsible for property damage due to
improper installation or water connection.
Water pressure must be between 35 to 100 pounds
per square inch to function properly, A minimum
pressure of 35 pounds per square inch is
recommended for refrigerators with water filters,
• Adjust freezer control (see page 14:).Freezer is
recommended to be approximately 0° F (-18° C).
Water pressure must be between 35 to 100 pounds
per square inch to function properly. A minimum
pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Check water connection procedure in your
Installation Instructions. Self-piercing and 3/,_..saddle
valves cause low water pressure and may clog tile
line over time. Sears is not responsible for
property damage due to improper installation
or water connection. Open water valve
completely and check for leaks.
• Turn off water supply and remove kinks. If kinks
cannot be removed, replace tubing.
28