Filter
Top Products
Door £einstallation
Materials Needed:
• Phillips screwdriver
• 5/d' hex head driver
2_
3_
1. Install hinge assemblies:
• Install center hinge with Phillips screws.
Place hinge side of refrigerator door
on center hinge pin.
• Install top hinge with 5/,?,hex head
sorews.
While holding refrigerator door
upright, tighten down top hinge
with %" hex head driver.
4. Reconnect two-pin connector.
5. Replace top hinge covers.
f
Metal Door Handle
Materials Needed:
• 3/_2"Allen wrench
• Gloves to protect hands
i Note: Metal handles scratch doors.
can
To Remove:
• Loosen set screws in handle using 3_2"Allen
wrench.
• Repeat the procedure on all screws.
To Replace:
• Align handle with the mounting posts.
• Apply upward pressure to the handle and hold.
• Fully tighten all set screws to secure handle in
place.
]
Connecting the Water Supply
to ice Maker
To reduce the risk of injury or death, follow
basic precautions, including the following:
• Read all instructions before installing ice maker.
• Do not attempt installation if instructions are not
understood or if they are beyond personal skill
level.
• Observe all local codes and ordinances.
Do not service ice maker unless specifically
recommended in Use & Care Guide or published
user-repair instructions.
Disconnect power to refrigerator before installing
ice maker.
• Water damage due to an improper water
connection may cause mold/mildew growth. Clean
up spills or leakage immediately!
To avoid property damage or possible injury,
follow basic precautions, including the
following:
• Consult a plumber to connect W' O.D. copper
tubing to household plumbing to assure
compliance with local codes and ordinances.
• Confirm water pressure to water valve is between
35 and 100 pounds per square inch, 20 pounds
per square inch without filter.
Do not use a self-piercing, or _,?' saddle valve.
Both reduce water flow and can become clogged
over time, and may cause leaks if repair is
attempted.
• Tighten nuts by hand to prevent cross threading.
Finish tightening nuts with pliers and wrenches.
Do not over-tighten.
• Wait two to three hours before placing refrigerator
into final position to check and correct any water
leaks. Recheck for leaks after 24 hours.
• Verify the copper tubing under the sleeve is
smooth and free from defects. Do not reuse an
old sleeve.
10