Kenmore 625.343950 Water Dispenser User Manual


 
4
PARTS OF THE SYSTEM
n filter system assembly, including mounting bracket
and screws
n water supply saddle valve
n filtered water faucet, for sink or countertop mountĆ
ing
Note: Deluxe models include an electronic indicator
faucet base and battery pack.
n 3/8" tubing and fittings to make all needed connecĆ
tions
n Teflon tape for fittings
MATERIALS AND TOOLS NEEDED
D plumbers putty
D slotted and Phillips screwdrivers
D pliers and adjustable jaw wrench
D hand or battery powered drill and 1/8" bit (if need
ed for saddle valve installation, see page 5)
D electric drill and 3/4" bit (type as required) if
mounting hole is needed for the faucet, see pages 5
and 6
CAUTION: To avoid damaging the sink, consult a
qualified plumber or installer for drilling procedures
in porcelain or stainless steel.
TYPICAL UNDERSINK INSTALLATION
FIG. 1
Note:
Be sure to allow a minimum space of 1–1/2” under
the system for removing the sumps, to change the
cartridges.
shutoff valve
Note:
To change the fil-
ter cartridge, you must
turn off the water. A
nearby
shutoff valve is
convenient. Most sinks
already have shutoff
valves on the supply
pipes.
HOT COLD
SINK
filtered water
faucet
saddle valve
washer
adaptor
nut
tubing
WATER
IN
mounting
screw (2)
insert
nut
tubing
WATER
OUT
Filter I
Filter II