Filter
Top Products
SECTION 5 SERVICE mECH. INFORMATION
A. TROUBLESHOOTING
NEUTRAUZER FILTER
FILTERED WATER IS ACID
(LOW pH)
TASTE & ODOR RLTER
FILTERED WATER bIAS TASTE
AND/OR ODOR
NEEDS REFILL OF i I NEEDS REPLACEMENT
NEUTRALITE M INERAL OF ACTIVATED CARBON
MINERAL
ALLFILTERS I
FILTEREDWATER CONTAINSSEDIMENTS,
(SAND,StLT,,DIRT,ETC.)OR IRON
!
I IRONINWATERREQUIRES I
OTHERWATERCONDITIONING
(HAVEWATERANALYZED)
1
V,SUA OHEO S
1. Is raw water pipe plumbed to valve inlet?
i Is plumbing bypassvalve(s) in service?
Is valvedrainhoseunobstructed?
TIMER SHOWSWRONGTIME I
AND DAY AND/0B S FLASH NG I
=
Electrical power was off. I
i
Resetall timer programming
I
Investigatereasonfor
powerloss. Besureout-
let for filter cannotbe
switchedoff.
J DoManualAdvance I
Diagnosticto verify pro-
per function.
f
f f
PROGRAMMINGOK I TOOFEW BACK-
i
FORFAMILY NEEDS I WASHESPRO-
GRAMMED.
1. Leakingfaucetor REPROGRAM_ Do ManualAdvanceDiagnosticto l
stool I _ ver fy proper function.
I
2. Filteredwaterusebl
atoutaidefaucetsLI DOMANUALADVANCETOI /
3. Otherunusualfil- r,P-i FILLCYCLE- CHECKFILL
teredwaterusage/I FLOWTO SOLUTONB0rFLE /
/
TIMER DISPLAYSHOWSCORRECT
TIME ANDDAY, AND IS STEADY
i
OBSERVEVALVE CAM POSITION
l
I'N ERV, EPDS,,,ONI [ OTINSERV,OEPOSITIO I
TESTWATERATFILTEREDWATER / 1. Wiring harness has loose
FAUCETCLOSESTTO FILTER J connections, or defective
t 2. Switch defective
_ 3. Valve motor inoperative
t NOSED'MENTS1 WATER CONTAIN 4
INWATER I SEDIMENTS 1
ICHECKPROGRAMMINGI
Filterregeneratedsince
customerrailed. Checkfor
correctregenerationpro-
gramming.
f
[ Do Manual Advance Diagnostic I
to verify proper function.
/
/
/
[TIMERDISPLAYDLANKI
÷
Check electrical power
to timer (outlet, trans-
former, all connections)
t
IPOWEROKAYI
FACEPLATE
DEFECTVE
/
/
/
FACEPLATE REPLACEMENT: BE SURE THE VALVE IS IN SERVICE POSITION (OBSERVE VALVE
CYCLE INDICATOR) WHEN REPLACING THE FACEPLATE.
If after installing and programming the replacement faceplate, the valve is not in M
service position, do the following to assure correct cycle orientation, or timing,
between the faceplate and valve.
S • (SERVICE)
Use the MANUAL ADVANCE procedures, page 5- 3. With the the RECHARGE
button, advance through the recharge cycles until the valve stops in service posi-
tion, and RECHARGE no longer flashes in the timer. Valve
Cam
NOTE: The valve motor may automatically drive through several valve positions
while searching for service.
5-4
Valve
Position
Indicator
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line