Filter
Top Products
17
†
The maximum additional water used for any combination of options is 2.6 gal. (10.0 L).
Dishwasher Control Section
Sani Rinse
This high temperature option sanitizes
your dishes and glassware in
accordance with National Sanitation
Foundation (NSF)/ANSI Standard 184
for Residential Dishwashers. Certified
residential dishwashers are not
intended for licensed food
establishments. The Sani indicator
indicates at the end of the cycle
whether the Sani Rinse option was
successfully completed. If the
indicator does not activate, it is
probably due to the cycle being
interrupted.
Pots & Pans
Normal Wash
Increases the main wash
temperature from 105°F
(41°C) to 120°F (49°C)
and the final rinse from
140°F (60°C) to 155°F
(68°C).
55 100
0 - 1.8
(0 - 7.0)
Heated Dry
Turns the heat element on after the
wash cycle is completed. Use rinse
aid with or without the Heated Dry
option for best drying results. Plastic
items are less likely to deform when
loaded in the top dish rack.
Available with
any cycle
except
Quick Rinse
Turns the heat element
on at the end of the
wash cycle.
32 32 0
Delay Hours (on some models)
Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak
hours when possible.
To delay the start
1. Select a wash cycle and options.
2. Press the delay button.
3. Press START/RESUME.
NOTE: Anytime the door is opened (such as, to add a dish), the START/RESUME button must be pressed again, to resume the
delay countdown.
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When LOCK ON is lit, all buttons are
disabled. The dishwasher door can still be opened/closed while the controls are locked.
To turn on the Lock
Press and hold CONTROL LOCK for 3 seconds. LOCK ON will light up. If you press any pad while your dishwasher is locked,
the light flashes 3 times and an audible tone will sound.
NOTE: The dishwasher cannot start if the control is locked.
To turn off the Lock
Press and hold CONTROL LOCK for 3 seconds. The light turns off.