Filter
Top Products
How much detergent to use
• The amount of detergent to use depends on the
hardness of your water and the type of detergent. If you
use too little, dishes won't be clean. If you use too
much in soft water, glassware will etch.
Water hardness can change over a period of time. Find
out your water's hardness by asking your local water
department, water softener company, or county
extension agent.
Different brands of dishwasher detergent have different
amounts of phosphorous for softening water. Ifyou
have hard water and use a detergent with a
phosphorous content of less than 8.7%, you might
need to use more detergent, or use a detergent with a
phosphorous content higher than 8.7%.
Where to fill
Top of 3rd step (3 tbs or 45 g)
Top of 2nd step (2 tbs or 30 g)
Top of 1st step (1 tb or 15 g)
Water Hardness Amount of Detergent
Soft to Medium For normally soiled loads:
Hard Water
• Partially fill the Main Wash
section (2 tbs or 30 g)0 to 6 grains per
gallon
• Partially fill the Pre-Wash
section (2 tbs or 30 g) if
needed
NOTE: Add only 1 tb or 15 g of
detergent to both sections if
dishes are pre-rinsed or the water
is very soft (0 to 2 grains per
gallon).
For heavily soiled loads:
= Fill the Main Wash section
(3 tbs or 45 g)
• Partially fill the Pre-Wash
section (2 tbs or 30 g)
Medium to Hard
Water
7 to 12 grains per
gallon
For normally soiled and
heavily soiled loads:
• Fill the Main Wash section
(3 tbs or 45 g)
• Partially fill the Pre-Wash
section (2 tbs or 30 g) if
needed
i
NOTE: Fillamounts shown are for standard powdered
detergent. Amounts may vary ifyou use liquid or
concentrated powdered detergent. Follow instructions on
the package when using liquid dishwasher detergent or
concentrated powdered detergent.
RinseAidDispenser
Rinse aids prevent water from forming droplets that can
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes during the final
rinse by releasing a small amount of the rinse aid into the
rinse water. Your dishwasher is designed to use a liquid
rinse aid. Do not use a solid or bar-type.
Checking the dispenser
Check the center of the Fill Indicator cap, Clear means it
needs filling.
Or you can remove the Fill Indicator cap. If an "E" is visible,
the dispenser is empty.
Filling the dispenser
The rinse aid dispenser holds 6 oz (175 mL) of rinse aid.
Under normal conditions, this will last for about three
months. You do not have to wait until the dispenser is
empty to refill it. Try to keep itfull, but be careful not to
overfill it.
1. Make sure the dishwasher door is completely open.
2. Remove the Fill indicator cap.
3. Add rinse aid. Fillto the smallest opening inthe lower
part of the dispenser. Overfilling can cause the rinseaid
to leak out, and could cause overeudsing.
4. Clean up any spilled rinse aid with a damp cloth.
5. Replace the Fill Indicator cap. Close tightly.
12