Kenmore 7280 Range User Manual


 
26
Care & Cleaning
To remove oven door:
1. Open oven door completely (horizontal with floor - Fig.1).
2. Pull the door hinge locks on both left and right door hinges
down from the oven frame completely towards the oven door
(Fig. 2). A tool such as a small flat-blade screwdriver may be
required.
3. Firmly grasp both sides of oven door along the door sides (Do
not use the oven door handle - Fig. 3).
4. Close the door to the broil stop position (the oven door will stop
into this position just before fully closing).
5. With the oven door in the broil stop position, lift the oven door
hinge arms over the roller pins located on each side of the oven
frame (Fig. 4).
To replace oven door:
1. Firmly grasp both sides of oven door along the door sides (Do
not use the oven door handle - Fig. 3).
2. Holding the oven door at the same angle as the removal
position, seat the hook of the hinge arm over the roller pins
located on each side of the oven door frame (Fig. 4). The hook
of the hinge arms must be fully seated onto the roller pins.
3. Fully open the oven door (horizontal with floor - Fig. 1).
4. Push the door hinge locks up towards and into the oven frame
on both left and right oven door hinges (Fig. 2) to the locked
position; then close the oven door.
Special door care instructions
Most oven doors contain glass that can break. Read the following
recommendations:
Removing and replacing the lift-off oven door
Do not close the oven door until all the oven racks are fully in
place inside the oven cavity.
Do not hit the glass with pots, pans, or any other object.
Scratching, hitting, jarring or stressing the glass may weaken its
structure causing an increased risk of breakage at a later time.
To avoid possible injury
when removing or
replacing the oven door, follow the instructions below carefully
and always hold the oven door with both hands positioned away
from the door hinge area.
The door is heavy. For safe, temporary storage,
lay the door flat with the inside of the door facing down.
Fig. 3
Oven door
hinge
locations
Fig. 1
Fig. 2
Fig. 4
L
O
C
K
about
10°
hinge
oven
door
roller
pin
hinge
arm