Filter
Top Products
Setting Surface Controls
Setting the Dual Ring Burner
The Dual Ring Burner has two rings of flame that you can
control for two different heat levels, one for small and one
for large cookware.
Large Coakware Operation (Figure 1; Zone A & B)
1. Place a large cooking
utensil centered over
the dual surface Burner
Grate.
2. Push the surface control
knob down and turn
counferclockwlse out of
the OFF position.
3. Release the knob and
rotate to the LITE
position (Figures 2 & 3).
4. Vlsually check that the
burner has llt.
5. When the burner is lit,
continue to turn the
Figure 2
control knob counferclockwlse between the HI position
and the MED position to adjust to the desired flame
size for both burners together (Figure 1).
Simmering Operation (Figure 1; Zone A)
1. Place a small cooking utensil centered over the dual
surface Burner Grate.
2. Push the surface control knob in and turn
counferclockwlse out of the OFF position (Fig. 2 & 3).
3. Release the knob and rotate to the UTE position.
4. Vlsuaffy check that zone A & B of dual burner has llt.
5. Continue to turn the gas control knob counterclockwise
past the MED position; zone B will turn off. Adjust the
simmer flame size by turning the control knob between
the MED position to the LO position.
important notes:
° DO NOT cook with the surface control knob left in the
LITE position. (The electronic ignitor wiii continue to spark
if the control knob setting remains in the LITE position).
° When setting any surface control knob to the LITE
position° aii electronic surface ignitors wiii spark at the
same time. However° only the surface burner you are
setting wiii ignite.
° NFVl:R place or straddle a cooking utensil aver two
different surface cooking areas at the same time. This
can cause uneven heating results.
Figure 1
DUAL RING BURNER
OFF
LITE
Figure 3
13
Figure 4