Filter
Top Products
Surface Cooking
Placement of Burner Bases and Caps
(Models with sealed burner only)
Your cooktop is equipped with three different sized burners: Power Burner
(large), Standard Burner (medium) and Simmer Burner (small).
Place the burner base over each gas opening, matching the burner base
size with the gas opening size. Place the burner cap on each burner
base, again matching the cap size to the burner base size. The cap for
the each Burner has an inner locating ring which locates the burner cap
in the center of the burner.
Make sure each burner cap is properly aligned and level.
Turn the burner on to determine if it will light. If the burner does not
light, contact a Sears Service Center. Do not service the sealed burner
yourself.
Sealed Burner
Setting Surface Controls
The surface control knobs shown
below may not look identical to the
Surface Controls Knobs on your
range; They are only representational.
Open Burner Models
To Adjust Low or "Simmer" Setting (some models)
The burner flame, at low setting, can be adjusted if it is too high or too low;
refer to the Installation Instructions for adjustment procedure.
To operate the Surface Burner:
1. Place cooking utensil on burner.
2. Push in and turn the Surface Control knob to LITE. Note: All electronic
ignitors will click at the same time. However, only the burner you are
turning on will ignite.
3. Visually check that the burner has lit.
4. After the burner lights, turn the control knob to the desired flame size. The
control knobs do not have to be set at a particular mark. Use the guides
and adjust the flame as needed. DO NOT cook with the control knob in the
LITE position. (The electronic ignitor will continue to click if left in the LITE
position.)
8