Filter
Top Products
General Cleaning
Cleaning Various Parts of Your Appliance
Before cleaning any part of the warmer drawer, be sure all controls are turned OFF and the warmer drawer is COOL.
REMOVE SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS NOW WILL
REDUCE THE EXTENT AND DIFFICULTY OF MAJOR CLEANING LATER.
Surfaces
Glass
Drawer Front Panel
Plastic
Control Knobs
Stainless Steel
Porcelain Enamel
Body Parts and Drawer Cavity
Warmer Drawer Rack
How to Clean
You may use a glass cleaner on the outside glass of the drawer. DO NOT
immerse the drawer in water. DO NOT spray or allow water or the glass cleaner
to enter behind the drawer glass panel. DO NOT use oven cleaners, cleaning
powders or any harsh abrasive cleaning materials on the outside of the drawer.
To remove control knob, turn to the OFF position; grasp firmly and pull straight off
the shaft. Clean with a cloth soaked in soapy water. Rinse with a clean water and
a dishcloth. To replace knob after cleaning, line up the flat sides of both the knob
and the shaft; then push the knob into place.
Note: Humidity controller knob cannot be removed.
Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean
water and a cloth. Do not use cleaners with high concentrations of chlorides
or chlorines. Do not use harsh scrubbing cleaners. Only use kitchen cleaners
that are especially made for cleaning stainless steel. Always be sure to rinse the
cleaners from the surface as bluish stains may occur during heating that cannot
be removed.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a
1:1 solution of clear water and ammonia. If necessary, cover difficult spots with
an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and
a damp cloth, and then scrub with a soap-filled scouring pad. Rinse and wipe dry
with a clean cloth. Remove all cleaners or the porcelain may become damaged
during future heating. DO NOT use spray oven cleaners.
The rack may be removed for cleaning. If removed, clean by using a mild,
abrasive cleaner following manufacturer's instructions. Rinse with clean water and
dry.
...........ii.......