Filter
Top Products
Setting Oven Controls
• Setting the Clock
• Changing between 12 or 24 hour
display
Cone Cenv Cony
Bake Roast Convert
_-_ _
Pre
Heat Bake Broil
W "-_J "--J
Slow Warm& Flex
Cook Hold Clean
Cook Delay Timer Add 1
Time Start Set/Off Minute
Recipe 0 @
Recal| @
1 2 3
4 5 6
7 8 9
STJZ0 @Cle_t
Oven
_ Lockout
Setting the Clock
The CLOCK (_r_) pad is used to set the clock. The clock may be set for 12 or 24 hour time of
day operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash (See Fig. 1).
INSTRUCTIONS PRESS DISPLAY
To set the clock (example below for 1:30):
1. Press @. "CLO" will appear in the display (Fig, 2).
2. Press @ @ @ pads to set the time of day to 1:30(Fig. 3).
"CLO" will appear in the display. Press _. "CLO" will
disappear and the clock will start (Fig, 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold {'Q} for 6 seconds (Fig. 3). While holding the
pad down the current time of day will remain and "CLO" will
disappear from the display (Fig, 4). CONTINUE holding the pad
until a beep is heard,
2. The display will show either "12h"(Fig. 5)or"24h"(Fig. 6).
3. Press c_oo..... to switch between the 12 and 24 hour time of day
display, The display will show either "12h" (Fig, 5) or "24h" (Fig,
6).
4. Press _ to accept the desired change or press @ to
reject the change,
5. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
@
®@@
@
for 6 seconds
Clean
Fig. 2
Fig. 3
Fig. 4
13
Fig. 5
Fig. 6