Filter
Top Products
Before Setting Oven Controls
Baking Layer Cakes with 1 or 2 Oven Racks
For best results when baking cakes using 2 oven racks, place cookware on rack positions 2 (Flat Handle Oven Rack) & 5
with the Offset Oven Rack (See Fig. 6). For best results when using a single oven rack, place cookware on rack position 4
(See Fig. 7).
Air Circulation in the Oven
For best air circulation and baking
results allow 2-4" (5-10 cm) around
the cookwa refor proper aircirculation
and be su repans and cookwa redo not
touch each other, the oven door, sides
or back of the oven cavity. The hot air
must be able to circulate around the
pans and cookware in the oven for
even heat to reach around the food.
Fig. 6 Fig. 7
Before Setting Surface Controls COOKTOP
• Locking & Unlocking the Cooktop _ LOCKOUT
To Set the Cooktop Lockout Feature
The _-Q_ pad is used to activate the Cooktop Lockout feature which will lock all surface
elements from being accidentally turned ON (including Warmer Zone). This feature will only
lock the cooktop.
To turn the Cooktop Lockout Feature ON:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold _ until a 2nd beep sounds. If a triple beep sounds instead, check
all surface elements and turn them to the OFF position and repeat this step. The Cooktop
Locked indicator light will turn ON and the cooktop controls and functions are locked out
until the cooktop is unlocked (See Fig. 1).
Fig. 1
To turn the Cooktop Lockout Feature OFF:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold _ until a 2nd beep sounds (after 3 seconds). If a triple beep sounds
instead, check all surface elements and turn them to the OFF position and repeat this
step. The Cooktop Locked indicator light will turn OFF and the cooktop may be used
normally (See Fig. 2).
Fig. 2
Note: Starting a Self-Clean cycle will automatically turn ON the Cooktop Lockout feature.
The cooktop will remain locked until the Self-Clean cycle has completed and the oven door
has unlocked. If a power failure occurs after the Cooktop Lockout has been activated, you
must turn OFF the Cooktop Lockout feature before being able to use the cooktop features
again.