Filter
Top Products
9
ENGLISH
Before Setting Surface Controls
• General Cooktop Information
• About Radiant Surface Elements
• Locations of the Radiant Surface Elements and Controls
• Locking & Unlocking the Cooktop
About the Ceramic Glass Cooktop
The ceramic cooktop has radiant surface elements located below
the surface of the glass. The design of the ceramic cooktop
outlines the area of the surface element underneath (See Figs. 1,
2, 3 & 4).
Heat is transferred up through the surface of the cooktop to the
cookware. The type and size and condition of the cookware, the
number of surface elements in use and their settings, are all
factors that will affect the amount of heat that will spread to areas
beyond the surface elements. Note: The areas surrounding
the elements may become hot enough to cause burns.
About the Radiant Surface Elements
The element temperature rises gradually and evenly. As the
temperature rises, the element will glow red. To maintain the
selected setting, the element will cycle on and off. The heating
element retains enough heat to provide a uniform and consistent
heat during the off cycle. For efficient cooking, turn off the element
several minutes before cooking is complete. This will allow any
remaining heat to complete the cooking process.
NOTE: Be sure to read detailed instructions for ceramic glass cooktop cleaning in the General Care & Cleaning section
and Before You Call checklist section of this manual.
NOTE: Radiant elements have a limiter that allows the element to cycle on and off, even at the HI setting. This helps to prevent
damage to the ceramic smoothtop. Cycling at the HI setting is normal and can occur if the cookware is too small for the radiant
element or if the pan bottom is not flat. Refer to page 17 for more details about using proper cookware on the cooktop.
Fig. 1
Fig. 2
To Set the Cooktop Lockout Feature
The pad is used to activate the Cooktop Lockout feature which will lock all surface
elements from being accidentally turned ON (including Warmer Zone). This feature will only
lock the cooktop.
To turn the Cooktop Lockout Feature ON:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold until a 2nd beep sounds. If a triple beep sounds instead, check
all surface elements and turn them to the OFF position and repeat this step. The Cooktop
Locked indicator light will turn ON and the cooktop controls and functions are locked out
until the cooktop is unlocked (See Fig. 5).
To turn the Cooktop Lockout Feature OFF:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold until a 2nd beep sounds (after 3 seconds). If a triple beep sounds
instead, check all surface elements and turn them to the OFF position and repeat this
step. The Cooktop Locked indicator light will turn OFF and the cooktop may be used
normally (See Fig. 6).
Fig. 6
Fig. 5
Note: Starting a Self-Clean cycle will automatically turn ON the Cooktop Lockout feature. The cooktop will remain locked until
the Self-Clean cycle has completed and the oven door has unlocked. If a power failure occurs after the Cooktop Lockout has
been activated, you must turn OFF the Cooktop Lockout feature before being able to use the cooktop features again.
Fig. 3 Fig. 4