Filter
Top Products
UpperHexagonal
HeadScrew
. HingeCap
TopHinge
DISASSEMBLY DIAGRAM FOR
REVERSING THE DOOR SWING
REVERSING THE DOOR SWING
Refer to the disassembly diagram and change the
door hinges in the following procedure. The
numbers in the diagram indicate the procedure
order in the instructions+
1. Remove the hinge cap by twisting it off,
2. Remove the upper hexagonal head screws.
The refrigerator door can now be removed.
3+Tilt the refrigerator back or lay it on its back for
steps 4, 5 and 6. Use a pad or blaqk_{to
protect the floor and to avoid scratching the
painted finish.
4. Remove the leveling legs by turning them
counterclockwise. Remove the lower
hexagonal head screws, two on tt_e hinge side
and one near the front corner of the other side.
5, Attach the left side leg and leg spacer to the
+ other side hole which was positioned
symmetdcaUy.
6. Attach+the bottom hinge symmetrically to the
other side of the cabinet.
.
Remove the upper hinge plastic pins and
insert them in the holes from which the screws
were removed in Procedure 2.
8. Take off the hinge collar cap using a
screwdriver and insert them in the hinge collar
on the opposite side.
9. Attach the shaft to the refrigerator door. Attach
the door to the bottom hinge and secure them
with the screws from Procedure 4.
10.
11.
Sha_
BottomHinge
Spacer_ i
'_ , (_; LowerHexago.a,
Leg ++ - Leg HeadScrew
Attach the upper hinge to the refrigerator door.
Do not tighten the screws completely.
The direction in which the door opens has now
been changed; however, the following points
should be checked:
a. Make sure the door is on straight.
b+ Make sure that there is no space between
the door gasket and the refrigerator unit
itself when the door is closed.
c. Make sure that gasket on the hinge side is
not caught between the door and the unit
when the door is opened or closed. (If the
door is forced closed when the gasket is
caught, the gasket may be damaged.)
When checking the above points, if it is
discovered that the door is not installed
properly (this is apt to happen at the first try),
loosen the screws holding the upper hinge,
straighten the door and tighten the screws
slowly with the socket wrench. After making
sure that the door is installed correctly, tighten
all the screws holding the hinge. If they are not
tightened, the door may slip out of position or
there may be an opening between the door
and the unit.
12. Stand the unit back in the upright position.