Filter
Top Products
11
ENGLISH
Temperature Controls
SYSTEM-MONITORING ALARMS
The electronic control system continuously monitors your refrigerator/freezer
for temperature consistency, doors left ajar, and power failures. Variances
from normal operating conditions are communicated by audible tones and
a set of four status indicator lights.
RESPONDING TO ALARMS (AUDIBLE TONES &
INDICATOR LIGHTS)
USING THE ALARM RESET BUTTON
You can disable or activate the alarm system
by pressing and holding the Alarm Reset
button for three seconds. Use it, for example,
to turn off audible tones and/or flashing
indicator lights.
Once you disable the alarm system, you must
again press and hold the Alarm Reset button
for three more seconds to reset (activate) the
alarm system. The On indicator light remains
off while the Freezer and Fresh Food
compartments cool toward the current
temperature settings. When temperature
settings are reached, the On light displays
green to indicate an active alarm system.
TURNING THE COOLING SYSTEM ON AND OFF
You can disable the cooling system in your refrigerator by pressing the
On/Off button located on the left side of the temperature control panel. To
ensure that you do not accidentally turn off the cooling system, the button
does not work unless you press and hold it for three seconds. Once you
disable the cooling system, all refrigeration to the freezer and fresh food
compartments stops. To turn the cooling system back on, you must again
press and hold the On/Off button for three more seconds.
NOTE: Each time you make settings on the control panel, a single
audible tone acknowledges your input.
Alarm Reset Button
Indicator Lights
Cooling
System
On/Off
Button
IMPORTANT: The On/Off button only controls your refrigerator’s
cooling system. Power to lights and other electrical components
continues unless you unplug the power cord.
Alarm
Name
Indicator
Light
Audible
Tones
Condition
How To Respond
On
(light is
off)
Alarm system is not
active while Freezer
and Fresh Food
compartments are
cooling toward the
current temperature
settings.
If Freezer and Fresh Food
compartments do not match your
temperature settings in three
hours, expect the control system
to signal other conditions. If
cooling does not stabilize toward
your current settings, call for
assistance.
Steady
Green
Alarm system is
active.
No response required.
Door
Ajar
Flashing
Green
9
Freezer or Fresh
Food door has been
open for over five
minutes.
Close door to disable and reset
alarm.
High
Temp
Flashing
Amber
9
Freezer or Fresh
Food compartment
has been too warm
(45° F or higher) for
over an hour.
Press Alarm Reset button to turn
off alarm. If temperatures do not
improve, call for assistance.
Power
Failure
Flashing
Amber
A power outage
was detected.
Press Alarm Reset button to turn
off alarm and again to reset.
Check if the power failure lasted
long enough to affect stored food
temperatures.
The alarm system does not
automatically reset if you disconnect
and reconnect your refrigerator’s power
cord. It can only be reactivated by
pressing the Alarm Reset button.