Filter
Top Products
- STEP 3: INSTALL FAUCET (cont.)-
B. ASSEMBLE FAUCET
ULTRAFILTER 150
1. Loosely assemble the base, spacer, washer and
plastic nut onto the faucet stud.
2. Route the 1/4" red tubing through the sink or
countertop hole and connect to 1/4" barb on faucet.
3. Route the 3/8" black tubing through sink or the
countertop hole and connect to 3/8" barb on faucet.
4. Attach the 3/8" blue tubing to the faucet stud us-
ing the tubing adaptor.
5. Lower faucet into place on the countertop, on the
underside of the countertop or sink slide the slotted
washer into place and tighten plastic nut. Tighten
the nut so the faucet cannot move, but do not over-
tighten.
UltraFilter 150
faucet & spout
H hole in sink or
b__i_ bers
slotted washer _ (_
""
washer -......._(_
hex nut _ (_
1/4" red tubing
from RO drain
(connect to 1/4"
barb on faucet)
3/8" blue tubing
(connect to stud
on faucet)
tubing adaptor
(connects to
/bottom of stud)
3/8" black tubing to
drain point (connect
to 3/8" barb on faucet)
/
Figure 6
7
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line