Kenwood CM750 Water Dispenser User Manual


 
KENWOOD CM750 SERIES
care and cleaning
care
Always switch off and unplug before cleaning.
Never put the machine in water or let the flex or plug get wet.
water filter cartridge
If you’re using this instead of the flow control block, change it every
month. To remove it, twist and pull. For replacement water filter
cartridges see ‘service and customer care’ page 5.
remember
1 Before fitting the cartridge, immerse it in water for 10 minutes first to
remove any air bubbles.
2 After fitting it, run two lots of water through the machine (without
coffee).
cleaning
The parts below (except the body) are dishwasher safe.
jug, lid
Push the lid off . Wash, then dry.
filter holder, permanent filter
Wash, then dry. The flow control block only needs washing
and flow control block occasionally.
body
Wipe with a damp cloth, then dry. Don’t use abrasives - they’ll scratch
the plastic.
filter door
1 Remove it: open, lift, then unslot the bottom
2 Wash, then dry.
descaling
If you use the flow control block instead of a water filter cartridge, you’ll
occasionally need to descale. You’ll know when limescale has built up
because your coffee will take longer to come through.
to descale
1 Buy a suitable descaler.
2 Fit the flow control block, not a water filter cartridge.
3 Descale the machine.
4 After descaling, run several lots of water through the machine to clean
it out. Fill the tank to the top cup mark when you do this. If you decide
to use a water filter cartridge, fit it
after this cleaning stage.
5 Wash the parts.
GB
4