Filter
Top Products
2
key
processor
ቢ
power unit
ባ
detachable drive shaft
ቤ bowl
ብ
lid
ቦ
feed tube
ቧ pushers
ቨ
safety interlock
ቩ
cord storage
ቪ pulse control
ቫ
speed control
liquidiser
ቭ
filler cap
ቮ lid
ቯ
jug
ተ
sealing ring
ቱ blade unit
additional attachments
Not all of these attachments listed below will be included with your food
processor. Please refer to your content list supplied. To buy an attachment not
included in your pack, contact the dealer from whom you purchased your
a
ppliance.
ቲ knife blade
ታ dough tool
ቴ twin beater geared whisk
ት maxi-blend canopy
ቶ thick slicing/coarse shredding disc
k thin slicing/fine shredding disc
k fine (Julienne style) chipper disc
k rasping disc (if supplied)
k geared citrus press (if supplied)
k mill (if supplied)
to use your food processor
1 Fit the detachable shaft onto the power unit ᕡ.
2 Then fit the bowl. Place the handle towards the back and turn clockwise until it
locks ᕢ.
3 Fit an attachment over the drive shaft.
●
Always fit the bowl and attachment onto the machine before adding ingredients.
4 Fit the lid ᕣ - ensuring the top of the drive shaft locates into the centre of the lid.
●
Do not use the lid to operate the processor, always use the on/off
speed control.
5 Switch on and select a speed.
●
The processor won’t work if the bowl and lid are fitted
incorrectly.
●
Use the pulse control for short bursts. The pulse will operate for as long as the
lever is held down.
6 Reverse the above procedure to remove the lid, attachments and bowl.
●
Always switch off before removing the lid.
important
●
Your processor is not suitable for crushing or grinding coffee beans, or
converting granulated sugar to caster sugar.
●
When adding almond essence or flavouring to mixtures avoid contact with the
plastic as this may result in permanent marking.
21
22
23
24
25
a
before using your Kenwood appliance
●
R
ead these instructions carefully and retain for future reference.
●
R
emove all packaging and any labels.
safety
●
The blades and discs are very sharp, handle with care.
A
lways hold the knife blade by the finger grip
k
at the top, away from the cutting edge, both
when handling and cleaning.
●
A
lways remove the knife blade before pouring contents from the bowl.
●
K
eep hands and utensils out of the processor bowl and liquidiser jug whilst
connected to the power supply.
●
S
witch off and unplug:
●●
b
efore fitting or removing parts
●●
after use
●●
b
efore cleaning
●
N
ever use your fingers to push food down the feed tube. Always use the
pusher/s supplied.
●
B
efore removing the lid from the bowl or liquidiser/mill from the power unit:-
●●
s
witch off;
●●
wait until the attachment/blades have completely stopped;
●
●
B
e careful not to unscrew the liquidiser jug or mill from the blade unit.
●
L
iquids should be allowed to cool to room temperature before blending.
●
Do not use the lid to operate the processor, always use the on/off speed control.
●
This machine will be damaged and may cause injury if the
interlock mechanism is subjected to excessive force.
●
N
ever use an unauthorised attachment.
●
Never leave the machine on unattended.
●
Never use a damaged machine. Get it checked or repaired: see ‘service’.
●
Never let the power unit, cord or plug get wet.
●
Don’t let excess cord hang over the edge of a table or worktop or touch hot
surfaces.
●
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
●
Children should be supervised to ensure that they do not play with the
appliance.
●
Only use the appliance for its intended domestic use. Kenwood will not accept
any liability if the appliance is subject to improper use, or failure to comply with
these instructions.
●
Misuse of your processor/liquidiser can result in injury.
before plugging in
●
Make sure your electricity supply is the same as the one shown on the
underside of your machine.
Important – UK only
●
The wires in the cord are coloured as follows:
Blue = Neutral, Brown = Live.
●
The appliance must be protected by a 3A approved (BS1362) fuse.
Note:
●
For non-rewireable plugs the fuse cover MUST be refitted when replacing the
fuse. If the fuse cover is lost then the plug must not be used until a replacement
can be obtained. The correct fuse cover is identified by colour and a
replacement may be obtained from your Kenwood Authorised Repairer (see
Service).
●
If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An
electric shock hazard may arise if an unwanted non-rewireable plug is
inadvertently inserted into a 13A socket outlet.
●
This appliance conforms to EC directive 2004/108/EC on Electromagnetic
Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on materials
intended for contact with food.
before using for the first time
1 Remove all packaging including the plastic blade covers from the knife blade.
Take care the blades are very sharp. These covers should be discarded
as they are to protect the blade during manufacture and transit only.
2 Wash the parts see ‘cleaning’
3 Push excess cord into the back of the machine.
k
a