Kenwood FP710 Food Processor User Manual


 
before using your Kenwood appliance
Read these instructions carefully and retain for future reference.
Remove all packaging and any labels.
safety
The blades and discs are very sharp, handle
with care. Always hold the knife blade
by the finger grip at the top, away
from the cutting edge, both when
handling and cleaning.
Do not lift or carry the processor by the handle - or the handle
may break resulting in injury.
Always remove the knife blade before pouring contents from the
bowl.
Keep hands and utensils out of the processor bowl and liquidiser
jug whilst connected to the power supply.
Switch off and unplug:
before fitting or removing parts
after use
before cleaning
Never use your fingers to push food down the feed tube. Always
use the pusher/s supplied.
Before removing the lid from the bowl or liquidiser/mill from the
power unit:-
switch off;
wait until the attachment/blades have completely stopped;
be careful not to unscrew the liquidiser jug or mill from the
blade unit.
Allow all liquids to cool to room temperature before placing them
in the liquidiser.
Do not use the lid to operate the processor, always use the on/off
speed control.
This machine will be damaged and may cause injury
if the interlock mechanism is subjected to excessive
force.
Never use an unauthorised attachment.
Never leave the machine on unattended.
Never use a damaged machine. Get it checked or repaired: see
‘service’.
Never let the power unit, cord or plug get wet.
Don’t let excess cord hang over the edge of a table or worktop
or touch hot surfaces.
Do not exceed the maximum capacities stated.
Do not let infirm people use the appliance without supervision.
Do not let children use or play with the appliance.
Only use the appliance for its intended domestic use. Kenwood
will not accept any liability if the appliance is subject to improper
use, or failure to comply with these instructions.
before plugging in
Make sure your electricity supply is the same as the one shown
on the underside of your machine.
This appliance complies with European Economic Community
Directive 89/336/EEC.
before using for the first time
1 Remove all packaging including the plastic blade covers from the
knife blade. Take care the blades are very sharp. These
covers should be discarded as they are to protect the blade
during manufacture and transit only.
2Wash the parts see ‘cleaning’
3 Push excess cord into the back of the machine.
key
processor
power unit
detachable drive shaft
bowl
lid
feed tube
pushers
safety interlocks
cord storage
speed control
liquidiser
filler cap
lid
jug
sealing ring
blade unit
additional attachments
Not all of the attachments listed below may be included with
your food processor. Attachments are dependent upon the
model variant.
knife blade
dough tool
twin beater geared whisk
maxi-blend canopy
thick slicing/coarse shredding disc
thin slicing/fine shredding disc
fine (Julienne style) chipper disc
rasping disc
geared citrus press
mill
mini processor bowl
KENSTORE™ attachments carousel
spatula
2