Kenwood MX320 series Mixer User Manual


 
know your Kenwood kitchen machine
safety
Switch off and unplug before fitting or removing tools, after use and before cleaning.
Keep children away from the machine and never let the cord hang down where a child could
grab it.
Keep your fingers away from moving parts and fitted tools. Never put your fingers etc in the
hinge mechanism.
Never leave the machine on unattended.
Never use a damaged machine. Get it checked or repaired: see ‘service’, page 7.
Never use an unauthorised tool.
Never operate the mixer with the head in the raised position.
Never let the power unit, cord or plug get wet.
Never exceed the maximum capacities on page 5.
Take care when lifting this appliance as it is heavy. Ensure the head is locked and that the
bowl, tools, and cord are secure before lifting.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance.
Only use the appliance for its intended domestic use. Kenwood will not accept any liability if
the appliance is subject to improper use, or failure to comply with these instructions.
before plugging in
Make sure your electricity supply is the same as the one shown on the underside of
your machine.
important - UK only
The wires in the cord are coloured as follows:
Green and Yellow = Earth,
Blue = Neutral,
Brown = Live.
The appliance must be protected by a 13A approved (BS1362) fuse.
WARNING: THIS APPLIANCE MUST BE EARTHED.
Note:
For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse
cover is lost then the plug must not be used until a replacement can be obtained. The
correct fuse cover is identified by colour and a replacement may be obtained from your
Kenwood Authorised Repairer (see Service).
If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock
hazard may arise if an unwanted non-rewireable pug is inadvertently inserted into a 13A
socket outlet.
This appliance conforms to EC directive 2004/108/EC on Electromagnetic Compatibility and
EC regulation no. 1935/2004 of 27/10/2004 on materials intended for contact with food.
before using for the first time
1 Remove all packaging, including the fitment around the bowl.
2 Wash the parts: see ‘care and cleaning’, page 6.
2